VEHICLE WAS WORKING FINE WHEN PARKED A FEW WEEKS AGO, NOW WENT TO MOVE IT AND CLUTCH WENT TO FLOO...
Q&A
Ask Your QuestionAll 1990 Chevrolet S10
Question
CLUTCH PEDAL FLOORS AND WONT RETURN WITHOUT HELP, AND NO CLUTCH RESISTANCE.
Question
I have a 1982 S10 just got. Something under the dash that operates the clutch
wont start out of gear. So need to push clutch in. worked when given to me. is there a way to byp...
Question
Blinkers flash fine while driving but not flashing at idle.
1989 S10 base model 2wd. The blinkers were working sporadically before purchase. (i.e.- not alway...
Question
how to replace oil pump. does transfer case have to be removed?
low oil pressure
Question
when i turn on left signal on it turns fuel pump and coil starts arcing
also the hazard wont work unless headlights are on i replaced signal light switch and flasher it ...
Question
No blower fan at any setting and ac compressor does not turn on
Sitting at a light today it all just stopped. All fuses are good however
Question
i have an 89 s10 2.5 exhast manifold glows red when reving engine up.
engine starts fine idles fine for about 2-3 min then idles erratic and sputters out tail pipe hav...
Question
Why is my S10 idling too high in neutral?
my 94 chevy s10 idles too high when in neutral or when the clutch is depressed.
Question
how do i check the injector pulse on my s10,
i've got fuel to the throttle body but not thru the injectors
Question
TailLights StopWorking, FusesBulbs=Good, Brake/Turns work. 1983 S-10
I have traced back to the connector right behind the wheel well and the frame on the drivers sid...
Question
Runs great at any speed but idles very weak and stalls frequently at stops.
1989 Chevy S-10 4.3L V-6. When engine is cold I have to depress gas pedal to get engine to start...
Question
What are the procedures for replacing the cigarette lighter switch.
How do I replace the cigarette lighter switch on a 1984 S-10.
Question
how much would an exhaust system coast
need pipe cat and muffler
Question
what would be the cost for an entire exhaust syetem for my 1988 S10
back muffler is gonethe cat has holes in it and so does the pipping from engine to end
Question
where is the oil pressure sending unit located on 2.8 v6 ?
I have no oil pressure reading on my gauge.
-
Verified
Quality Work -
Guaranteed
Fair Prices -
Happy
Customers
This week's top 10
| 1 globalhelper | 6 goodguy |
| 2 wetry | 7 ebans777 |
| 3 ziptie12 | 8 FREDDY BLUE |
| 4 wenyan | 9 Superior Auto Diesel Repair |
| 5 tunnelram | 10 team g performance |