2003 Chevrolet Monte Carlo Questions

Answered 2003 Chevrolet Monte Carlo Questions

Ask a Question
View:RecentAnsweredUnanswered
I have 183000 miles on the car. It is strong with a good engine but when I takeoff or pick up speed it jumps a little .What to do?
Had my system scanned because the service trac light came on as well as the tracoff and abs lights. Was told it was a bad sensor which is in the hub. Replaced the hub. How do I reset the lights
Just need to know the size of belt I put on
Do I have to tighten the bolt on the belt tensioner to do so? I had mistakenly taken the belt tensioner off completely to change the belt. I put it back on the right way, but I want to be sure about the tension cause ...
I'm trying to change my water pump, but I can't loosen the tension pulley to remove the serpentine belt. The tension pulley has a square hole that I can't fit any sockets into, what kind of tool do you need to loosen...
Well dis da deal da screws came out of da EGR VALVE n me not knowing kept riding it like dat caused da EGR Tube to break on both ends n i tryna find out were due I go to buy dem n how due I put dem on. Thank u so much...
The window comes down easily, but does not go up unless I move the button around and find a spot that makes contact. I do not know how to get access and expose the contacts so I can clean them.
i do think that wen we used 2 get gas the check engine light would come on for a bit then go off
the check engine light is on computer came up with knock sensor and evap system.a wire was loose on knock sensor.
FLUSHED COOLING SYSTEM, REPLACED WTR PUMP & THERMOSAT.WILL WORK FINE TILL I GET GOING ABOUT 1 MILE. STARTGETTING HOT. I CAN STOP PUT IT IN NEUTRAL GIVE IT SOME GAS AND IT WILL COME DOWN TO A NORMAL RANGE WITH NO HEAT ...
The Serpentine Belt Tensioner Pulley froze up and the beltbroke.