Close

2012 Chevrolet Malibu Problems

RepairPal has identified the most common problems with the 2012 Chevrolet Malibu based on complaints from actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
Get a Repair Estimate For Your 2012 Chevrolet Malibu
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more
14
Known Problems

Acid may leak from the battery at the cable connections, resulting in corrosion on the battery cable ends and in the battery tray. A Leaking battery should be replaced and the cables thoroughly cleaned or replaced if necessary.

The ignition switch may fail causing a no start condition. This is not generally a theft system (passlock) issue because the security light does not illuminate or flash.

Vehicles with a 6speed automatic transmission may develop one or more of the following faults related to a broken 35R clutch wave plate inside the transmission: Illumination of the Check Engine Light with code P0716, P0776, P0717, P0777, P2714, P2715, and/or P02723, loss of reverse gear, slipping or harsh 3rd or 5th gear shift. Removal and dis-assembly of the transmission will be required to replace the broken 35R wave plate. It is also extremely important that all debris from the failed part be cleaned from the transmission while it is disassembled in order to try and prevent future problems.

Vehicles with a V6 engine may develop an oil leak from the front crankshaft seal. Our technicians tell us a revised front crankshaft seal is available to correct this concern.

Various issues with the electric power steering system may develop and could require replacement of steering column assembly.

The instrument panel and switch backlighting may fail due to a faulty dimmer control module. A failed module will require replacement.

The passlock sensor in the ignition lock cylinder may fail causing an anti-theft system fault and a no start condition. Our technicians tell us that the ignition lock cylinder should be replace to correct this condition.

The HVAC blower motor may stop working at one or more speeds due to a faulty blower motor resistor block. Our technicians recommend to confirm the resistor is at fault by first checking the operation of the switch.

The fuel pump may fail causing the engine to stall and not restart. Our technicians recommend replacing the fuel filter every 30,000 miles to help prevent undue strain on the fuel pump.

Illumination of the Check Engine Light can be caused by a loose or worn gas cap.

The front struts may show signs of wear, or be excessively bouncy ride at freeway speeds. This may begin to occur at around 75,000 miles.