The ignition switch may fail causing a no start condition. This is not generally a theft system (passlock) issue because the security light does not illuminate or flash.
Problems for specific Chevrolet Malibu years:
Car problem reports
Problem with your car? See what our experts say or submit your own.
Repairpal verified 2011 Chevrolet Malibu problems
Transmission Fault and/or Check Engine Light With Code P0716, P0776, P0717, P0777, P2714, P2715, and/or P02723
Vehicles with a 6speed automatic transmission may develop one or more of the following faults related to a broken 35R clutch wave plate inside the transmission: Illumination of the Check Engine Light with code P0716, P0776, P0717, P0777, P2714, P2715, and/or P02723, loss of reverse gear, slipping or harsh 3rd or 5th gear shift. Removal and dis-assembly of the transmission will be required to replace the broken 35R wave plate. It is also extremely important that all debris from the failed part be cleaned from the transmission while it is disassembled in order to try and prevent future problems.
The front struts may show signs of wear, or be excessively bouncy ride at freeway speeds. This may begin to occur at around 75,000 miles.
The passlock sensor in the ignition lock cylinder may fail causing an anti-theft system fault and a no start condition. Our technicians tell us that the ignition lock cylinder should be replace to correct this condition.
Vehicles with certain V6 engines may illuminate the Check Engine Light one or more of the following codes: P0011, P0014, P0021, P0024, P0341, P0346, P0336, or P0391. Our technicians tell us that some vehicles may require a powertrain control module (PCM) software update to correct this issue. Other vehicles may have excess camshaft end play on one or both cylinder heads which will need to be corrected using special procedures outlined by GM.
Vehicles with V6 engines may see the 30amp high speed cooling fan fuse may blow due to high start up loads associated with the high speed cooling fan motor. Our technicians tell us the high speed cooling fan wiring and fuse should be upgraded to a 40amp circuit to correct this concern. The fan wiring MUST be upgraded along with the fuse to handle the increased current flow.