2005 Chevrolet Malibu Problem Reports

RepairPal Verified 2005 Chevrolet Malibu Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

The ignition module or an ignition coil may fail causing the engine to misfire which can cause the Check Engine Light to illuminate or begin flashing.

The ignition module or an ignition coil may fail causing the engine to misfire which can cause the Check Engine Light to illuminate or begin flashing.

The intake manifold gasket may develop and external engine oil or coolant leak. In some cases, an internal coolant leak may occur causing coolant to mix with the engine oil. Our technicians tell us that operating the engine  with a coolant/oil mix can result in internal engine damage. Replacing the intake manifold gasket should correct these leaks.

The fuel gauge may not read correctly and/or the Check Engine Light may illuminate with code P0455/P0461 stored for a fuel level sensor issue. These faults may be caused by a fuel vapor line inside the fuel take interfering with the fuel level sensor. If this is found to be the case, repositioned and securing the vapor line should correct this concern. If no fault is found with the fuel vapor line, the fuel level sensor itself may be at fault.

Illumination of the Check Engine Light can be caused by a loose or worn gas cap.

The HVAC blower motor may stop working at one or more speeds due to a faulty blower motor resistor block. Our technicians recommend to confirm the resistor is at fault by first checking the operation of the switch.

The turn signal switch may fail causing the hazard/turn signal flasher to continue to click even when the turn signal switch is off. Replacing the faulty turn signal switch will commonly correct this condition.

The automatic transmission shifter may fail causing the ignition key to become stuck in the ignition lock cylinder.

Front brake rotors can wear causing a pulsation felt in the brake pedal. Our technicians often recommend replacement of the front rotors and brake pads as the best option to correct this condition.

The heater core under the right side of the dashboard may leak engine coolant which can puddle on the passenger front floor. The loss of coolant may cause an engine overheating condition. Our technicians tell us that removal of the dash board is necessary to replace the heater on these vehicles.

Various electrical issues may be caused by poor terminal contact at the body control module (BCM) electrical connectors. Proper diagnoses will be required to confirm faults are related to poor BCM connections.

The passlock sensor in the ignition lock cylinder may fail causing an anti-theft system fault and a no start condition. Our technicians tell us that the ignition lock cylinder should be replace to correct this condition.

Various issues with the electric power steering system may develop and could require replacement of steering column assembly.

Vehicles with a V6 engine may develop an oil leak from the front crankshaft seal. Our technicians tell us a revised front crankshaft seal is available to correct this concern.

The front window sash brackets may break causing the window to come off track. Our technicians tell us that new brackets are available and can be installed on the old window glass if it is not damaged.