2005 Chevrolet Malibu Problems
RepairPal has identified the most common problems with the 2005 Chevrolet Malibu as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
The instrument panel and switch backlighting may fail due to a faulty dimmer control module. A failed module will require replacement.
Various issues with the electric power steering system may develop and could require replacement of steering column assembly.
The ignition switch may fail causing a no start condition. This is not generally a theft system (passlock) issue because the security light does not illuminate or flash.
The fuel gauge may not read correctly and/or the Check Engine Light may illuminate with code P0455/P0461 stored for a fuel level sensor issue. These faults may be caused by a fuel vapor line inside the fuel take interfering with the fuel level sensor. If this is found to be the case, repositioned and securing the vapor line should correct this concern. If no fault is found with the fuel vapor line, the fuel level sensor itself may be at fault.
The passlock sensor in the ignition lock cylinder may fail causing an anti-theft system fault and a no start condition. Our technicians tell us that the ignition lock cylinder should be replace to correct this condition.
The intake manifold gasket may develop and external engine oil or coolant leak. In some cases, an internal coolant leak may occur causing coolant to mix with the engine oil. Our technicians tell us that operating the engine with a coolant/oil mix can result in internal engine damage. Replacing the intake manifold gasket should correct these leaks.
The turn signal switch may fail causing the hazard/turn signal flasher to continue to click even when the turn signal switch is off. Replacing the faulty turn signal switch will commonly correct this condition.
The 2004-2010 Chevrolet Malibu has known issues with the EVAP system, a part of your emission control system.
To correct the issue, the EVAP canister vent valve, solenoid, and wiring must be inspected. The most common fix is replacement of the wiring connector or replacement of the vent valve assembly.
Various electrical issues may be caused by poor terminal contact at the body control module (BCM) electrical connectors. Proper diagnoses will be required to confirm faults are related to poor BCM connections.
Vehicles with a V6 engine may develop an oil leak from the front crankshaft seal. Our technicians tell us a revised front crankshaft seal is available to correct this concern.
Illumination of the Check Engine Light can be caused by a loose or worn gas cap.
The heater core under the right side of the dashboard may leak engine coolant which can puddle on the passenger front floor. The loss of coolant may cause an engine overheating condition. Our technicians tell us that removal of the dash board is necessary to replace the heater on these vehicles.