2000 Chevrolet Malibu Problems

RepairPal has identified the most common problems with the 2000 Chevrolet Malibu as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

Refine by vehicle
×
Choose your vehicle
24
Known Problems

The ignition switch may fail causing a no start condition. This is not generally a theft system (passlock) issue because the security light does not illuminate or flash.

Vehicles with a 6speed automatic transmission may develop one or more of the following faults related to a broken 35R clutch wave plate inside the transmission: Illumination of the Check Engine Light with code P0716, P0776, P0717, P0777, P2714, P2715, and/or P02723, loss of reverse gear, slipping or harsh 3rd or 5th gear shift. Removal and dis-assembly of the transmission will be required to replace the broken 35R wave plate. It is also extremely important that all debris from the failed part be cleaned from the transmission while it is disassembled in order to try and prevent future problems.

The HVAC blower motor may stop working at one or more speeds due to a faulty blower motor resistor block. Our technicians recommend to confirm the resistor is at fault by first checking the operation of the switch.

The fuel gauge may not read correctly and/or the Check Engine Light may illuminate with code P0455/P0461 stored for a fuel level sensor issue. These faults may be caused by a fuel vapor line inside the fuel take interfering with the fuel level sensor. If this is found to be the case, repositioned and securing the vapor line should correct this concern. If no fault is found with the fuel vapor line, the fuel level sensor itself may be at fault.

The automatic transmission shifter may fail causing the ignition key to become stuck in the ignition lock cylinder.

Illumination of the Check Engine Light can be caused by a loose or worn gas cap.

The spark plugs should be replaced every 100,000 miles. Our technicians recommend replacing the spark plug wires also at this time.

The passlock sensor in the ignition lock cylinder may fail causing an anti-theft system fault and a no start condition. Our technicians tell us that the ignition lock cylinder should be replace to correct this condition.

The intake manifold gasket may develop and external engine oil or coolant leak. In some cases, an internal coolant leak may occur causing coolant to mix with the engine oil. Our technicians tell us that operating the engine  with a coolant/oil mix can result in internal engine damage. Replacing the intake manifold gasket should correct these leaks.

The heater core under the right side of the dashboard may leak engine coolant which can puddle on the passenger front floor. The loss of coolant may cause an engine overheating condition. Our technicians tell us that removal of the dash board is necessary to replace the heater on these vehicles.

The fuel pump may fail causing the engine to stall and not restart. Our technicians recommend replacing the fuel filter every 30,000 miles to help prevent undue strain on the fuel pump.

The instrument panel and switch backlighting may fail due to a faulty dimmer control module. A failed module will require replacement.

Acid may leak from the battery at the cable connections, resulting in corrosion on the battery cable ends and in the battery tray. A Leaking battery should be replaced and the cables thoroughly cleaned or replaced if necessary.

The turn signal switch may fail causing the hazard/turn signal flasher to continue to click even when the turn signal switch is off. Replacing the faulty turn signal switch will commonly correct this condition.