2001 Chevrolet Lumina Problem Reports

Newest 2001 Chevrolet Lumina Problem Reports

Report A Problem

Illumination of the Check Engine Light can be caused by a loose or worn gas cap.

The intake manifold gasket may develop and external engine oil or coolant leak. In some cases, an internal coolant leak may occur causing coolant to mix with the engine oil. Our technicians tell us that operating the engine  with a coolant/oil mix can result in internal engine damage. Replacing the intake manifold gasket should correct these leaks.

The crankshaft position sensor, ignition module, and/or powertrain control module (PCM) may fail resulting in illumination of the Check Engine Light with ignition system related fault codes stored in the PCM. Patience is necessary when dealing with this specific situation as normal diagnostic procedures are not effective. In many cases, the best option is to replace parts, one at a time until the fault is corrected.

Corrosion may develop at the connection between the ignition coil tower and spark plug wire resulting in an engine misfire. The Ignition coil and spark plug wire should both be replaced to correct this condition.

An engine oil leak may develop from the rear of the engine. This is commonly caused by a failed oil pump drive o-ring seal. The leaking o-ring should be replaced to correct this concern.

The catalytic converter may become plugged resulting in loss of engine power. General Motors has extended the catalytic convertor warranty on some models to 10 years or 120,000 miles. Please contact your local GM dealer to see if your vehicle is included.

The display on the heater and AC control panel may become dim or go completely blank. Our technicians tell us the control panel must be replaced to correct this fault.

The upper intake manifold gasket and/or a PCV vacuum lines/hoses can develop vacuum leaks with age. This type of leak can result in a higher that normal or rough idle.

Acid may leak from the battery at the cable connections, resulting in corrosion on the battery cable ends and in the battery tray. A Leaking battery should be replaced and the cables thoroughly cleaned or replaced if necessary.

The transmission pressure control solenoid may fail causing erratic shifting. Our technicians tell us that partial dis-assembly of the transmission is necessary to replace a failed pressure control solenoid.

The fuel pump may fail causing engine to stall and not restart.

A coolant leak may develop from the water pump. The engine may overheat as a result of the coolant loss. A leaking water pump should be replaced.

The steering may develop a clunk type noise from the upper intermediate steering shaft.  Our technicians tell us that you should check with your local GM dealer to find out what the latest repair is for this condition.

The high pressure power steering hose will commonly leak fluid; it should be replaced.