Q&A

I plan to remove the lower intake of my Lumina 3.1L V6 engine, and seal the ridges between the tw...

There are two springs with studs holding the exhaust pipe to the rear exhaust manifold. The studs...

Will bad Exhaust Flange Gasket and/or Exhaust spring connecting the exhaust manifold to the exhau...

Chevy Lumina 95 3.1L V6 engines do not use iginition distributor and its shaft, so there is a cir...

Chevy Lumina 95 3.1L engine's lower intake manifold has only gaskets to seal the front and b...

has spark, coil packs seem to ohm out good,trigger voltage from module with test light(only teste...

For a new remaufactured V6 3.1L engine, does it require retorqued cylinder heads after break-in p...

I recently had an oil change and was told that the pvc valve hose was cracked.

After started up the engine, the rpm gauge initially drops to about 600 rpm, then recovers to the...

I am installing a new rebuilt engine for my Chevy Lumina-sedan 3.1L 1995. An instruction is to pr...

Want to buy a stated 90k-mile used chevy 3.1L V6 engine,
do you know how to stress test the engi...

My 95 Chevrolet Lumina-Sedan/Coupe 3.1L SFI OHV 6cyl, has some hydrolyic valve lifters stuck afte...

I got a code 082 on my 95 chevy lumina 3.1 l. I replaced the crank sensor and the car still will...

Transmission makes clunking noise when warms up in Park or neutral. Raised front wheels off groun...

The hose leaks.