The ignition module or crankshaft position sensor may fail causing the engine to die and not restart. Diagnoses will be necessary to determine if the module or crank sensor is causing the no start condition.
1993 Chevrolet Lumina Problem Reports
Newest 1993 Chevrolet Lumina Problem Reports
An engine oil leak may develop from the oil pump drive O-ring. This can often be confused with an intake manifold gasket leak. Careful inspection is required to determine the exact cause of the leak. Replacement of the failed 0-ring will commonly correct this concern.
The upper intake manifold gasket and/or a PCV vacuum lines/hoses can develop vacuum leaks with age. This type of leak can result in a higher that normal or rough idle.
The rubber section of an automatic transmission cooler line may develop a fluid leak . In some cases the leaking section of hose can be replaced. In others, the complete cooler line must be replaced to correct this concern.
Body: A dirty throttle body may cause a lower than normal engine idle resulting in a stalling condition. A stalling condition may also result if an idle learn procedure is not performed if the battery goes dead or is disconnected.
The high pressure power steering hose will commonly leak fluid; it should be replaced.
One or more of the rear suspension links may become bent causing a severe rubbing noise.
when it starts it idles up and down and u can fell it when i try to drive it jerks and and it wont get up past 20 u can smell gas when i go in reverse it will just die
The engine temperature sensor wire for the engine temperature gauge, or warning light, may touch the rear exhaust manifold causing a short to ground causing erratic operation of the temperature gauge or warning light.
Fuel injectors can short-circuit electrically causing a rougher than normal idle and reduced performance.