2006 Chevrolet Impala Problem Reports

RepairPal Verified 2006 Chevrolet Impala Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

The mass air flow or crankshaft position sensor may fail causing the engine to intermittently stall. It may be necessary for the engine to cool down before it will restart.

Flex fuel vehicles can develop fuel calibration issues resulting in illumination of the Check Engine Light and/or lack of power. This commonly occurs if only short trips are taken after changing fuel type from E85 to gasoline or gasoline to E85. In most cases, the fuel calibrations can be reset for gasoline using a properly equipped scan tool.

Illumination of the Check Engine Light can be caused by a loose or worn gas cap.

A Loose or worn gas cap may cause Check Engine Light to illuminate.

The intake manifold gasket can develop external engine oil or coolant leaks. In some cases the failed gasket will leak coolant internally. The manifold gasket will need to be replaced to correct this issue.

The serpentine belt tensioner pulley may wear out. Our technicians tell us that in order to get a new pulley from General Motors you must purchase a complete belt tensioner assembly.

 

The automatic transmission shifter may fail, or a wire may break near the shifter causing the ignition key to become stuck in the ignition lock cylinder.

The transmission pressure control solenoid may fail causing erratic shifting. Our technicians tell us that partial dis-assembly of the transmission is necessary to replace a failed pressure control solenoid.

The speedometer or other instrument panel gauge may begin to work erratically at times. Our technicians tell us that the instrument cluster must be sent to a repair facility to correct this fault.

A dirty throttle body may cause a lower than normal idle and possible stalling condition. Performing a throttle body service will commonly correct this concern.

An engine oil leak may develop from the front crankshaft seal. Our technicians tell us a revised front crankshaft seal is available to correct this concern.

The steering may develop a clunk type noise from the upper intermediate steering shaft.  Our technicians tell us that you should check with your local GM dealer to find out what the latest repair is for this condition.

The high pressure power steering hose will commonly leak fluid; it should be replaced.