Problems for specific Chevrolet Impala years:
Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported 2005 Chevrolet Impala problems
The engine may start and stall with the security light flashing. This is commonly caused by a failed passlock sensor which is part of the ignition lock cylinder. A secondary cause could be the ignition switch itself. Worn contacts inside the ignition switch can cause voltage drop issues which can affect the passlock system. Proper diagnoses should be performed before replacing any parts.
if my car is parked on a hill and i have to put it in reverse it does a really hard jolt or a kick. while im driving it does it again around 30 mph and again around 60 mph. sometimes if im at a stop light it kind of jerks as i start to take off.
Illumination of the Check Engine Light can be caused by a loose or worn gas cap.
The intake manifold gasket can develop external engine oil or coolant leaks. In some cases the failed gasket will leak coolant internally. The manifold gasket will need to be replaced to correct this issue.
The intake manifold gasket may develop and external engine oil or coolant leak. In some cases, an internal coolant leak may occur causing coolant to mix with the engine oil. Running the engine with a coolant/oil mix may result in engine damage. Replacing the intake manifold gasket should correct this issue.
An engine oil leak may develop from the rear of the engine. This is commonly caused by a failed oil pump drive o-ring seal. The leaking o-ring should be replaced to correct this concern.
The serpentine belt tensioner pulley may wear out. Our technicians tell us that in order to get a new pulley from General Motors you must purchase a complete belt tensioner assembly.
The transmission pressure control solenoid may fail causing erratic shifting. Our technicians tell us that partial dis-assembly of the transmission is necessary to replace a failed pressure control solenoid.
The fuel pump may fail causing engine to stall and not restart.
The speedometer or other instrument panel gauge may begin to work erratically at times. Our technicians tell us that the instrument cluster must be sent to a repair facility to correct this fault.