2004 Chevrolet Impala QuestionsRefine by vehicle
I see that there is a very common problem in the 04' Chevy Impala. My transmission sometimes slips, shifts hard or jerks really hard coming out of 1st gear at a dead stop. I love my car however it's really annoying.
And if the manifold needs to be replaced will it cause the car to just stop running or possibly create a fire?
Connected two different auto computers and neither codes.. already replace spark plugs, lock cylinder, coolant temp sensor, thermostat.. car will crank but the motor will not start. Please I need help asap for this is my only mode of transportation for my family and I to get to work and the store..
idle is very rough on take off
Need to take it in to the store so they can see which one I need
I've been having problems with my battery not keeping a charge. We put a shut off switch on the battery, but still pulling about 4 amps. We checked all the fuses and not the problem, and have a strong battery, and this started out of the blue about a month ago & can't seem to find the problem, Help please
My low engine oil light came on. Went to check my oil and it appears there is coolant in the oil.
2004 Chevy impala 3.4l 250,000 miles car was running fine filled up at gas station drove appx 10 miles car shook n fell dead n hasn't started since 15 months ago I had fuel pump fuel filter n fuel pressure regulator changed warranty has expired when it almost cranks im pushing pedal to try n keep it started n it pops n dies.....do you think the fuel pump has went out again? Thanks in advance
Bought a 04 impala from a local dealer. Had for 2 weeks and its starting to shift a tad hard. Got oil changed and said tranny needs serviced. They suggest a flush but i did my research and it suggested that it was not good to flush the tranny. Should i get just a fluid change, filter and drop pan ? It has 139,459 miles on it.
The battery was completely dead super dead and now my car make a slight grind, a brief seconds and then cranks. Check engine light will not go off.
My blower motor jus went out. I jus got a new one but it's slightly different from my old one where as the old one did not have the rubber hose out the side like my new one. Any suggestions??