2012 Chevrolet Camaro QuestionsRefine by vehicle
While attempting a code scan to see if anything was being thrown following the appearance of, or shall I say, transfer between, the driver seat airbag idiot light to the steering wheel airbag idiot light after replacing the seat, I found that the car had also thrown the B.S. B2aaa code that people claim GM has allegedly installed in many of their vehicles as a way of luring people in for service.
I cleared it by disconnecting the battery and pulling a few specific fuses for a bit then reattached them. Code is cleared. New airbag light still flashes, though. Anyone know anything, had experience with this? In case it comes back, I'd like to know, and anywhere else that I've found others have had this issue, it usually ends with a promise of an update... then silence.
If you have the answer to THIS ONE, I thank you a million times in advance!
Oddly enough, the idiot light for the steering wheel airbag just started to flash yesterday, but what triggered it was the replacement of the driver seat, which had been causing THAT airbag idiot light to flash until it was changed.
Somehow, by replacing the seat with the faulty airbag, which required me to pull the old seats connection pin and connect the new seat in its place during installation, I seem to have caused the issue that prompted the earlier recalls to show its ugly face.
But then, it's for the best I suppose, rather than waiting any length of time to manifest which would wind up leading me to wonder what had actually caused it later. At least this way I KNOW.
Different but Related Question to follow...
It is hard to get it into gears mostly 1,2,3 unless you turn off the car and reverse ...... if car is off its easy go right in ..... checked fluid it not low wanted to have lines checked fluid changed and bleed to see if that would fix it ....some places want to replace to much stuff without knowing for sure what wrong that could cost me from 1200 to 3000 dollars that I don't have
The radio looks like it's working, I can see the station and volume bar going up and down but no sound (I can't even hear the turn indicator clicking when I am using it during a turn). I checked the "audio muted" command -that's not it. Any suggestions as to how I can fix this problem?
Do you recommend certain mileage on the vehicle as when to change the rearend differential oil!?
I can hear a rub sound when making sharp turn and was told I need to change rear end fluids/seals.. The car only has 8,400 miles..
Sometimes it sounds as if it's coming from back drivers and I hear it more on the drivers side usually.