1995 Chevrolet Camaro Problem Reports
RepairPal Verified 1995 Chevrolet Camaro Problem Reports
An internal distributor fault could cause the Check Engine Light to illuminate, an engine misfire, or a stalling condition. Replacement of the distributor is commonly recommend to correct this concern.
Failure of the rear transmission mounts is common.
The intake manifold gasket may develop and external engine oil or coolant leak. In some cases, an internal coolant leak may occur causing coolant to mix with the engine oil. Our technicians tell us that operating the engine with a coolant/oil mix can result in internal engine damage. Replacing the intake manifold gasket should correct these leaks.
The tail or brake lights may be dim due to a poor ground connection inside the light socket. Failed light sockets will require replacement.
Corrosion may develop at the connection between the ignition coil tower and spark plug wire resulting in an engine misfire. The Ignition coil and spark plug wire should both be replaced to correct this condition.
The hood and rear hatch supports may fail causing the hood or hatch fall back down after being raised to the open position. Replacement of failed supports is recommended.
The t-top models are prone to water leaks from the t-tops weather strip seals. Our technicians tell us that replacing the all of the t-top related weather strips will commonly correct most leaks. Care should be taken when removing and installing the t-tops in order to avoid damage to the weather strips.
A coolant leak may develop from the water pump. The engine may overheat as a result of the coolant loss. A leaking water pump should be replaced.
Problems with the anti-theft systems using the raised-chip key can prevent the car from starting. The wires in the steering column to the ignition lock cylinder tend to break. The the key and ignition lock cylinder must be replaced to correct this condition.
The intake manifold gasket may develop external engine oil leak. The manifold gasket will need to be replaced to correct this issue.
A door window may move slowly or stop in mid travel due to a failing power window motor. The affected window may start working again after the motor cools off. Replacing the faulty window motor will commonly correct this concern.