1992 Chevrolet Camaro Problem Reports

Newest 1992 Chevrolet Camaro Problem Reports

Report A Problem

Failure of the rear transmission mounts is common.

The tail or brake lights may be dim due to a poor ground connection inside the light socket. Failed light sockets will require replacement.

A stalling issue may occur if the battery goes dead or is disconnected and the "idle learn" procedure is not performed. For more information on "relearning" the engine idle speed, please click here»

The fuel injectors may short out electricity causing a rougher than normal idle.

The trunk pull down switch may fail causing the trunk lid not to close completely. Our technicians tell us that the failed switch can be replaced without changing the complete pull down motor assembly.

The hood and rear hatch supports may fail causing the hood or hatch fall back down after being raised to the open position. Replacement of failed supports is recommended.

The t-top models are prone to water leaks from the t-tops weather strip seals. Our technicians tell us that replacing the all of the t-top related weather strips will commonly correct most leaks. Care should be taken when removing and installing the t-tops in order to avoid damage to the weather strips.

A coolant leak may develop from the water pump. The engine may overheat as a result of the coolant loss. A leaking water pump should be replaced.

Problems with the anti-theft systems using the raised-chip key can prevent the car from starting. The wires in the steering column to the ignition lock cylinder tend to break. The the key and ignition lock cylinder must be replaced to correct this condition.

Body: A dirty throttle body may cause a lower than normal engine idle resulting in a stalling condition. A stalling condition may also result if an idle learn procedure is not performed if the battery goes dead or is disconnected.

The fuel pump may fail causing the engine to stall and not restart. Our technicians recommend replacing the fuel filter every 30,000 miles to help prevent undue strain on the fuel pump.

A door window may move slowly or stop in mid travel due to a failing power window motor. The affected window may start working again after the motor cools off. Replacing the faulty window motor will commonly correct this concern.

The extension housing seals commonly leak.

The roller on the window guide attached to the bottom of the window glass may break off and cause the window to come off track.