Problems for specific Chevrolet Camaro years:
Problem Reports
Problem with your car? See what our experts say or submit your own.
1991 Chevrolet Camaro Problems
Rear Transmission Mounts Commonly Fail
Failure of the rear transmission mounts is common.
Dim Tail or Brake Lights Due to Faulty Light Sockets
The tail or brake lights may be dim due to a poor ground connection inside the light socket. Failed light sockets will require replacement.
Stalling Due to Ignition Module or Crankshaft Position Sensor Failure
The ignition module or the crankshaft position sensor may fail causing the engine to stall and not restart.
Fuel injectors can short-circuit
The fuel injectors may short out electricity causing a rougher than normal idle.
Trunk Lid Won't Close Due to Trunk Pull Down Switch Failure
The trunk pull down switch may fail causing the trunk lid not to close completely. Our technicians tell us that the failed switch can be replaced without changing the complete pull down motor assembly.
Hood and Rear Hatch Supports May Fail
The hood and rear hatch supports may fail causing the hood or hatch fall back down after being raised to the open position. Replacement of failed supports is recommended.
T-Top Models Are Prone to Water Leaks
The t-top models are prone to water leaks from the t-tops weather strip seals. Our technicians tell us that replacing the all of the t-top related weather strips will commonly correct most leaks. Care should be taken when removing and installing the t-tops in order to avoid damage to the weather strips.
Coolant Leak & Engine Overheating
A coolant leak may develop from the water pump. The engine may overheat as a result of the coolant loss. A leaking water pump should be replaced.
Car Won't Start and Security Light is On
Problems with the anti-theft systems using the raised-chip key can prevent the car from starting. The wires in the steering column to the ignition lock cylinder tend to break. The the key and ignition lock cylinder must be replaced to correct this condition.
Stalling or Low Engine Idle Speed Due to Dirty Throttle Body
Body: A dirty throttle body may cause a lower than normal engine idle resulting in a stalling condition. A stalling condition may also result if an idle learn procedure is not performed if the battery goes dead or is disconnected.
The Fuel Pump May Fail Causing the Engine to Stall or Crank Over But Not Start
The fuel pump may fail causing the engine to stall and not restart. Our technicians recommend replacing the fuel filter every 30,000 miles to help prevent undue strain on the fuel pump.
Power Window Not Working Due to Window Motor
A door window may move slowly or stop in mid travel due to a failing power window motor. The affected window may start working again after the motor cools off. Replacing the faulty window motor will commonly correct this concern.
Roller on window guide may break
The roller on the window guide attached to the bottom of the window glass may break off and cause the window to come off track.
-
Verified
Quality Work -
Guaranteed
Fair Prices -
Happy
Customers