1998 Chevrolet Blazer Problems
RepairPal has identified the most common problems with the 1998 Chevrolet Blazer as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
The intake manifold gasket may develop and external engine oil or coolant leak. In some cases, an internal coolant leak may occur causing coolant to mix with the engine oil. Running the engine with a coolant/oil mix may result in engine damage. Replacing the intake manifold gasket should correct this issue.
A door window may move slowly or stop in mid travel due to a failing power window motor. The affected window may start working again after the motor cools off. Replacing the faulty window motor will commonly correct this concern.
The power door locks may stop working in one or more doors due to a failed actuator. Replacement of the failed actuator should correct this concern.
The fuel level sensor in the fuel tank may fail causing erratic fuel gauge operation. Our technicians tell us that on high mileage vehicles you may wish to replace the complete fuel pump module assembly if this condition occurs.
On vehicles with intermittent windshield wipers, the wiper motor circuit board may fail and cause the wipers to stop working at times. Replacing the circuit board should resolve the issue. Some vehicles were recalled for this problem and some were not. You will need to check with your local dealer to find out if a specific vehicle was included.
Illumination of the Check Engine Light can be caused by a loose or worn gas cap.
The front or rear differential may develop an abnormal noise due to worn bearings or another internal fault. Our technicians tell us that a complete overhaul of the affected differential is commonly necessary to correct this condition.
The spark plugs should be replaced every 100,000 miles. Our technicians recommend replacing the spark plug wires also at this time.
The transmission output shaft seal may leak transmission fluid. On 2WD models, this leak can cause the transmission mount to become oil soaked, which will require replacement of the mount along with the leak repair. On 4WD models, if this seal leaks, the fluid will leak into the transfer case, causing it to become overfull.