1996 Chevrolet Blazer Problem Reports

RepairPal Verified 1996 Chevrolet Blazer Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

The distributor may develop internal faults. This can cause a rough running engine or stalling condition, the Check Engine Light may or may not illuminate. Our technicians tell us that the distributor should be overhauled or replaced to correct this concern.

Illumination of the Check Engine Light can be caused by a loose or worn gas cap.

The HVAC blower motor may stop working at one or more speeds due to a faulty blower motor resistor block. Our technicians recommend to confirm the resistor is at fault by first checking the operation of the switch.

The quick-connect fittings for the heater hoses tend to leak engine coolant. This problem commonly occurs because the metal housing has become brittle, which can break and cause leaks.

A door window may move slowly or stop in mid travel due to a failing power window motor. The affected window may start working again after the motor cools off. Replacing the faulty window motor will commonly correct this concern.

The transmission output shaft seal may leak transmission fluid. On 2WD models, this leak can cause the transmission mount to become oil soaked, which will require replacement of the mount along with the leak repair. On 4WD models, if this seal leaks, the fluid will leak into the transfer case, causing it to become overfull.

The electrical contacts in the ignition switch may fail and result in erratic instrument panel gauge operation or illumination of the Check Engine Light. A failed ignition switch will require replacement.

The heater core under the right side of the dashboard may leak engine coolant which can puddle on the passenger front floor. The loss of coolant may cause an engine overheating condition. Our technicians tell us that removal of the dash board is necessary to replace the heater on these vehicles.

On vehicles with intermittent windshield wipers, the wiper motor circuit board may fail and cause the wipers to stop working at times. Replacing the circuit board should resolve the issue. Some vehicles were recalled for this problem and some were not. You will need to check with your local dealer to find out if a specific vehicle was included.

The Anti-lock brake system (ABS) control unit may fail internally causing the ABS warning light to illuminate.

The power door locks may stop working in one or more doors due to a failed actuator. Replacement of the failed actuator should correct this concern.

The fuel pump may fail causing the engine to stall and not restart. Our technicians recommend replacing the fuel filter every 30,000 miles to help prevent undue strain on the fuel pump.