The distributor may develop internal faults. This can cause a rough running engine or stalling condition, the Check Engine Light may or may not illuminate. Our technicians tell us that the distributor should be overhauled or replaced to correct this concern.
Problems for specific Chevrolet 2500 Pickup years:
Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported 1990 Chevrolet 2500 Pickup problems
Intake Manifold Gasket May Leak Coolant or Engine Oil
The intake manifold gasket may develop and external engine oil or coolant leak. In some cases, an internal coolant leak may occur causing coolant to mix with the engine oil. Our technicians tell us that operating the engine with a coolant/oil mix can result in internal engine damage. Replacing the intake manifold gasket should correct these leaks.
Noise and/or Dead Battery Due to failed Alternator
The alternator may fail causing the battery to go dead, or an abnormal noise may develop. The dash warning light may or may not illuminate. A failed alternator will require replacement.
Power Brake Units May Leak Fluid From Hydro-Boost Unit
Power brake systems using "hydro-boost" may leak power steering fluid from the hydro-boost unit located behind the brake master cylinder. Replacement of the hydro-boost unit is the common repair to correct this concern.
Improper HVAC Temperature and/or Air Delivery Due to Failed Mode Door Actuator
One or more heater & AC (HVAC) air delivery and/or temperature mode door actuator may fail. This can result in incorrect air delivery or temperature. If this occurs, fault code(s) stored in the HVAC control module should be available to assist with diagnoses.
Overheating and/or Coolant Loss Due to Leaking Quick-Connect Fitting
The quick-connect fittings for the heater hoses tend to leak engine coolant. This problem commonly occurs because the metal housing has become brittle, which can break and cause leaks.
Abnormal Noise From AC Compressor
The air conditioning compressor may develop an abnormal noise and require replacement. We recommend that whenever an AC compressor is being replaced for a noise condition, a filter kit should be installed to prevent any metal particles in the system from damaging the new compressor.
Oil Leak From Distributor Shaft Seal
Power Door Lock Actuators May Fail
The power door lock actuators may become slow to operate or stop working completely and require replacement.
ABS Warning Light On and/or Erratic ABS Operation
The anti-lock brake system (ABS) front wheel speed sensors are prone to failure. When a sensor fails, the ABS warning light may illuminate and/or the ABS system may activate erratically.
Highter Than Nornal Idle Due to Vacuum Leak
The throttle body gasket may develop a vacuum leak which may result in a higher than normal engine idle. Failed gaskets will require replacement.
Coolant Leak & Engine Overheating
A coolant leak may develop from the water pump. The engine may overheat as a result of the coolant loss. A leaking water pump should be replaced.
Windshield Wipers May Fail Due to Faulty Wiper Motor Control Board
The windshield wipers may not work intermittently due to a faulty wiper motor control board. Our technicians tell us that lightly taping on the wiper motor when the fault occurs should temporarily get the wipers working again. Some vehicles were recalled for this problem and some were not. You will need to check with your local dealer to find out if a specific vehicle was included.
The Fuel Pump May Fail Causing the Engine to Stall or Crank Over But Not Start
The fuel pump may fail causing the engine to stall and not restart. Our technicians recommend replacing the fuel filter every 30,000 miles to help prevent undue strain on the fuel pump.
Inside/Outside Door Handles May Break
The inside and outside door handles are prone to breaking.