1991 Subaru Legacy Q&A

1991 Subaru Legacy Question: check engine light on

check engine light came on did self diagnosis, whould not show a code till I started it. 3 quick blinks repeated with pauses, stut off engine, disconnected green self diagnosis connecter. Drove it no light, drive it again a bit later light was back on. What is it? -
Answer 1
There is no code 3 or 30 for your Subaru, read the code retrieval procedures from Subaru, below is a link. Then you can deal with the problem much more effectively. Here is a link for repair info for your car http://bit.ly/mitchell_repair_manuals_online -
Related Items:
what dose it mean when the check engine light is on and the cruise control light is flashing?
Does the 1995 Legacy have the connector so I can take it to an auto parts place and have it hooked to the sensor to tell why the check engine light went on?
check engine light stays on
Every once in awhile my check engine light will come on and sometimes, after a few days of driving, it goes out. What could cause this?
The check engine light is on and the code reads "misfire on cylinder 3" (at Auto Zone)- the car seems to run fine but when you get to about 60 mph and at 3000 rpms it starts to falter. My DH has c...