Check Engine Light and Misfire Due to One or More Stuck Closed Fuel Injectors on GMC Yukon

One or more fuel injectors may become stuck closed causing an engine misfire  and the Check Engine Light to illuminate. Our technicians tell us that this problem can be caused by some fuel additives. There are special procedures which may be able to restore the affected injector. If this fails the affected injector must be replaced.

RepairPal Verified
Average mileage: 140,640 (100,100–223,000)
Engines affected: 5.7L V8, Gasoline
7 model years affected: 1996, 1997, 1998, 1999, more2000, 2003, 2007
13 people reported this problem
5 people shared problem details
My 99 gmc yukon recently started acting up on my way home from work. I barely made it home. When I have foot on gas ok when I take it off it starts shaking alot and hesitates. I used a scanner and found codes misfire codes maf sensor and o2 sensor bank 2 sensor 1 I changed the maf sensor changed o2 sensor and also did a complete tune up and also changed the fuel filter plugs wires dist cap eveything put in new gas. Still acting up took to local shop and they could not figure out the problem now my only choice is to take to dealer.
drives great but when still it shakes bad
1999 GMC Yukon173,000
dont have an answer, looking for the cure.
1999 GMC Yukon100,100
replaced all injectors $$$
2003 GMC Yukon- 5.7L V8223,000
The code keep reading random lean stay crock for a while than it cuts off. Its has a mis to it
Related Items:
will 93 octane cause my check engine light to come on
check engine light on .. scanned spark plug 4 replaced. cleared code. got gas . light came back...
installed vortex 5.7 engine ran good on highway for 15 minutes then it went dead I replaced the...
started rough idling out of the blue one morning.Fires right up and drives but rough. P0306 cod...
The engine may develop a misfire due to worn valve seats. This fault will cause the Check Engin...

Related Content