my check engine light has been on since approx.20,000 miles.i repair all the codes and now have approx.90,000. when i fix the codes the light goes off but usually a couple days later it comes back on. shows different code most times. any suggestions??????? this is a nissan maxima se 2000.
check engine light on 2000 Nissan Maxima
by Visitor in Danbury, CT on July 13, 2010
1 answer 1 comment
ANSWER by mastertech6371 on July 13, 2010
if the light is on then you did not fix the code. what is the codes?? 20,000 is a very long time. hope you have not complicated and compounded the problems. start with the codes then we will go from there. Roy
COMMENT by Visitor on September 05, 2010
I have a 2000 Maxima GLE and had a similar problem and have fixed it by replacing all the ignition coils, though you can replace just one if you know which one. It's a pretty frequent and thoroughly discussed problem on the maxima forums. If you're getting OBD error code P1320 then this will probably fix it. But check around to be sure. Replacing the coils can easily be done yourself, although a full set is about $300 http://autorepair.about.com/library/a/1i/bl039i.htm http://forums.maxima.org/search.php?searchid=1346588
I have gotten a tune up and I changed a fuel injector. I also changed the cam position sensor then I got a oil change and engine flush. My 1996 Nissan Maxima shakes while in drive and when im in pa...
I'm having problems,I have replaced my o2 sensor (bank 1 sensor 2) and no check engine light appears. i check the wiring up to the plug. then check the engine harness and found a wire gra...
How does the wheel speed sensor cause a check engine light. If it does should I replace the sensor?
...3.org/TR/REC-html40/loose.dtd"> The EGR valve can become clogged with carbon, which causes the Check Engine Light to illuminate. The valve needs to be removed and the system cleaned.
The Check Engine Light may illuminate indicating a primary ignition signal fault. Many times the cause is an ignition...