change oil sensor on 2008 Dodge Grand Caravan

changed oil couples of weeks ago , then reset the sensor but still comes on every time start the vehicle, thanks

by in Toronto, SD on November 30, 2013
1 answer 3 comments
ANSWER by on December 01, 2013
It didn't reset if it is still coming on. The routine is key on, but do not start the engine. Then slowly press the throttle to the floor and release three times within ten seconds of turning the key to the on position.
COMMENT by on December 05, 2013
thankyou very much for your help, today I faced another problem all of sudden my wipers wont shut off and no turn signals, greatly appreciate your help
COMMENT by on December 05, 2013
They are both controlled by the front control module. A technician with a full scan tool (preferably O.E. like a WiTech or StarMobile/StarScan) will be able to analyze what is going on.
COMMENT by on August 26, 2014
thanks u r very good
Related Items:
I have a P0420 code and engine light on. I am also going through a quart of oil every 1500 miles. No leaks underneath, no smoke coming out the tail pipe. The vehicle has 104,000 miles. My shop c...
1999 dodge grand caravan 3.8 LE. At what speed transmission should shift to top gear? Mine does at 45 mph. I think it should do at 35mph. Fluid was totally replaced by pumping it out and adding at ...
Just had my oil change now my oil lamp light comes on why is this coming on?
A delay in the transaxle engagement (greater than three seconds) may have multiple causes, including a defective pump, defective internal lip seals, valve body components, park-reverse-neutral-dr...
my van shuts off in the middle of driving and the oil light comes on. sometimes it stalls sometimes it just stops without warning. it will start back up sometimes and at others it won't. I had too ...

Related Content