2011 Volkswagen Jetta Repair and Maintenance
A guide to problems, costs, maintenance and repair for your 2011 Volkswagen Jetta
Verified by mechanics, reported by drivers like you
Ask a mechanic in our community
Never overpay. Check prices with our estimator
Our experts translate recalls into plain English
2011 Volkswagen Jetta ProblemsOdor From HVAC Vents
Condensation in the heater case may cause a musty odor from the heating, ventilation and AC (HVAC) system after sitting for two hours or more. Our technicians tell us that a cleaner is available for the heater case and the drain system should be checked for debris.
One or both head lights may not work due to premature head light bulb burnout and/or bulb harness failure. Care should be taken to inspect the head light harness connector for damage when replacing bulbs. Damaged connectors should be replaced.
An ignition coil or spark plug may fail unexpectedly resulting in an engine misfire and possible illumination of the Check Engine Light. Vehicles equipped with spark plug wires may also develop a misfire caused by a failed spark plug wire.
2011 Volkswagen Jetta QuestionsMy car sometime shaking and sometime when I driving stop (1 answer)
My car sometime shaking and sometime when I driving when I stop red light my car stop I start again
catalytic converter replaced 2x only has 100,000 miles
Car keys get stuck in ignition when the my car is on and I try to turn my car off.
2011 Volkswagen Jetta RecallsDriver's Frontal Air Bag Inflator Ruptures And Sprays Metal Fragments
The driver's frontal air bag inflator may deploy the air bag with excessive pressure, resulting in the inflator rupturing and causing metal debris to be sprayed onto vehicle occupants. Dealers will replace the driver's frontal air bag inflator free of charge to resolve the concern.
The driver's side air bag may not be powered due to a loss of electrical connection from the clock spring sliding contact in the steering wheel caused by contamination. Dealers will repair the vehicle free of charge.
If a rear suspension trailing arm becomes bent, its durability may be compromised and it could break unexpectedly. If this were to occur vehicle control would be affected, increasing the risk of a crash. When parts become available, dealers will install a sheet metal inlay on each of the rear axle trailing arms to prevent sudden loss of vehicle control should a rear trailing arm suddenly break.