» » » 2010

Resources for the Repair and Maintenance of your 2010 Toyota Venza

2010 Toyota Venza

Image for car images Toyota 2009 2011 Toyota Venza size thumb

2010 Toyota Venza Problems

Electrical & Lights -- Verified

The factory installed alarm system may sound for no apparent reason. A revised hood latch assembly is available which should correct this concern.

2010 Toyota Venza Recalls (Recent)

Body, Interior & Misc., April 9, 2013

RepairPal Expert Overview:

Vehicles have a tire size/weight rating label to inform owners of the carrying capacity of their vehicle. These models are being recalled because the incorrect vehicle weight rating is shown on the information label. This could result in vehicle and tire overloading, increasing the risk of tire failure. Owners will be provided an updated vehicle weight label to correct this concern.

Learn more »

Body, Interior & Misc., May 27, 2010

RepairPal Expert Overview:

Southeast Toyota is recalling 2005–2011 models for failing to comply with federal safety standards on tire selection and rims. Affected models were sold without the proper load-carrying capacity modification labels, which may cause the driver to overload the vehicle, increasing the chance of a crash. Dealers will mail the correct labels to the customer or install the label free of charge.

Learn more »

Body, Interior & Misc., May 27, 2010

RepairPal Expert Overview:

These vehicle were sold without the required load carrying captivity modification label. Dealers will mail the corrected label to vehicle owners. Owners have the option of requesting that the dealer install the label. This recall is expected to begin on May 27, 2010.

Learn more »

Body, Interior & Misc., March 30, 2010

RepairPal Expert Overview:

Toyota is recalling certain 2008-2010 Highlander, and 2009-2010 Corolla, Venza, and Matrix models because an unsecured or incompatible floor mat may cause the accelerator pedal to get stuck in the wide open position. This can cause high vehicle speeds and may make the vehicle difficult to stop, which can lead to a crash. Toyota will modify or replace the accelerators on the affected vehicles.

Learn more »

Electrical & Lights, March 7, 2012

RepairPal Expert Overview:

During assembly, the electrical contacts of the stop lamp switch may have been contaminated with silicone grease, causing increased electrical resistance in the switch. This could result in: Illumination of warning lamps; a no start condition; the shift lever may not shift from the Park position; and/or inoperative brake lights. Inoperative brake lights would fail to warn other drivers the vehicle is slowing or stopping, increasing the risk of a crash. Dealers will replace the brake light switch to correct this concern.

Learn more »

2010 Toyota Venza Questions and Answers

bigdaddyzr, 2010 Toyota Venza, 2.7L 4 Cylinder, Duluth, MN

took door panel off, window was frozen in track, removed window and re-installed, now power window goes to top and comes down by itself

venza2010, 2010 Toyota Venza, 3.5L V6, Minneapolis, MN

Should be the easiest job! Not, the wire housing goes into the car which means you have to take a lot of plastic off inside the car, which is impossible! Now I have half the job done and I have to ...

Write a Review About Your Car

2010 Toyota Venza Reviews

2010 Toyota Venza
I have driven my Venza for 9 months, and it has been the best all around vehicle I have ever owned. Plenty of room and more features per $ than any vehicle driven. Toyota did a great job on the styling of this vehicle, and the 20 inch tires are a nice touch. I really enjoy driving this car!!!

Recent Repair Estimates