2007 Toyota Tundra Repair and Maintenance
A guide to problems, costs, maintenance and repair for your 2007 Toyota Tundra
Never overpay. Check prices with our estimator
Verified by mechanics, reported by drivers like you
Ask a mechanic in our community
Our experts translate recalls into plain English
2007 Toyota Tundra ProblemsTicking Noise From Exhaust Manifold
The V8 models can experience exhaust manifold failures. A leaking exhaust manifold will sound like an exhaust leak or an audible ticking noise from the engine compartment and will be especially pronounced when the engine is still cold.
Four wheel drive models of the 2007 Toyota Tundra may suffer from premature failure of the rear driveshaft (prop shaft). Failure occurs at the u-joint due to insufficient material strength for the application.
When failure occurs, vibration increases with speed, and popping or clunking between gears is audible, especially when downshifting to accelerate or when shifting into drive or reverse.
Toyota has issued a revised part which will resolve the issue.
A defect in manufacturing may cause camshaft failure in the 2007 Toyota Tundra. The camshaft is too soft from the factory, and cam lobe wear is inevitable. This may cause:
- Check engine light illumination
- OBD trouble code p0300
- Rough idle
- Loss of power
- Poor fuel economy
2007 Toyota Tundra QuestionsMy 2007 Tundra won't turn on at times, just makes clicking sound. Problem? (1 answer)
I'll go to start it and only makes clicking sound. I'll give a couple more tries and it will start with no issues. It will be fine for awhile then make the same clicking sound when I go to start it. Any suggestions on what the issue could be?
when i connect
My tundra was running great and I started it up and the vsc light came on the same time the ck. engine lite came on and the 4 lo light is on but will not go in lo or high 4x4 and I can not go over 40mph. Any help . I have 60.000 on it .
2007 Toyota Tundra RecallsSeat Heater Wiring Shorts And Causes Fire
For vehicles equipped with aftermarket accessory seat heaters, the seat heater elements may short circuit when the seat cushion is compressed, and result in a fire hazard. Dealers will disconnect the seat heaters and refund the purchase price of the seat heaters free of charge to resolve the concern,
Southeast Toyota is recalling certain vehicles because the seat heater element may become damaged as a result of compression of the seat cushion. The damaged element could short causing burning of the seat cushion, increasing the risk of personal injury. Dealers will disconnect seat heaters with copper strand elements and refund the purchase price of the seat heater accessory to correct this concern.
Toyota and General Motors are recalling certain models because the power window master switch assembly in some of these vehicles was built using a less precise process for lubricating the internal components of the switch assembly. Irregularities in this lubrication process may cause the power window master switch assemblies to malfunction and overheat. This could result in the switch melting or possibly catching fire. Dealers will inspect and repair or replace the master window switch as necessary.