2010 Toyota Sienna Repair and Maintenance
A guide to problems, costs, maintenance and repair for your 2010 Toyota Sienna
2010 Toyota Sienna Problems
Models with electric sliding doors can develop problems with the door mechanism. The cable in the door becomes frayed, which will damage the electric motor.
2010 Toyota Sienna Questions
I have several scrapes and dents from rubbing against a cement column. Location of the damage is the driver's side sliding door. The area is about 20 by 12 inches.
I have a 2010 Toyota Sienna 3.5 V6. The engine starts every time, but stalls after a couple of seconds and does not idle.
I have checked the mass air flow sensor and it seems to have the right resistant between the THA and E2 pins, however, when battery voltage applied between pin1 and ...
What has to be done at the 5000 miles?
2010 Toyota Sienna Recalls
Toyota is recalling 1998–2010 Sienna models manufactured or registered in twenty-two Eastern and Midwestern states because of problems with the spare tire carrier and assembly cable due to road salt corrosion. This may cause the spare tire assembly cable to break and the spare tire to separate from the vehicle, increasing the risk of a crash. Toyota will notify owners via letter with instructions on how to remedy the problem. For a list of the affected states, call Toyota at 1-800-331-4331.
These vehicle were sold without the required load carrying captivity modification label. Dealers will mail the corrected label to vehicle owners. Owners have the option of requesting that the dealer install the label. This recall is expected to begin on May 27, 2010.
Southeast Toyota is recalling 2005–2011 models for failing to comply with federal safety standards on tire selection and rims. Affected models were sold without the proper load-carrying capacity modification labels, which may cause the driver to overload the vehicle, increasing the chance of a crash. Dealers will mail the correct labels to the customer or install the label free of charge.