2010 Toyota Camry Repair and Maintenance
A guide to problems, costs, maintenance and repair for your 2010 Toyota Camry
- Air Condition works irregularly, blow hut air.
- Is it normal to feel downshifting when slowing down or slowly descending a hill;
- Cost to replace charcoal canister, I live outside of the emission checking zone
- What maintenance does my car need at 55 or 60,000 mi?
- my toyota camry 2010 wipers will not stop running when the switch is off.
2010 Toyota Camry Problems
The Check Engine Light may illuminate because a component of the oxygen sensor stops working. As a result the engine computer is unable to determine the proper ratio of air to fuel for the engine. Replacing the failed oxygen sensor should correct this concern.
One or more motor mounts may wear out on cars with high mileage. This will put extra stress on the other mounts, and the faulty mount(s) should be replaced.
Cars equipped with an automatic transmission might experience a hesitation when accelerating. Revised software for the on board computer is available which may correct this problem. Software revisions are commonly most helpful on newer vehicles. once the mileage builds up a worn component could cause similar problems. Whenever major transmission work in performed, the transmission software should be updated as necessary.
2010 Toyota Camry Questions
125000 miles on car now. have never looked at the timing belt
2010 Toyota Camry Recalls
Southeast Toyota is recalling certain vehicles because the seat heater element may become damaged as a result of compression of the seat cushion. The damaged element could short causing burning of the seat cushion, increasing the risk of personal injury. Dealers will disconnect seat heaters with copper strand elements and refund the purchase price of the seat heater accessory to correct this concern.
Vehicles have a tire size/weight rating label to inform owners of the carrying capacity of their vehicle. These models are being recalled because the incorrect vehicle weight rating is shown on the information label. This could result in vehicle and tire overloading, increasing the risk of tire failure. Owners will be provided an updated vehicle weight label to correct this concern.
These vehicle were sold without the required load carrying captivity modification label. Dealers will mail the corrected label to vehicle owners. Owners have the option of requesting that the dealer install the label. This recall is expected to begin on May 27, 2010.
2010 Toyota Camry Reviews
I purchased my Camry new, but have had some surprising problems with it. As others have noted, alignment is a BIG problem. It always wants to pull to the left and I've had several alignments at several different places with the same result. My struts leaked and had to be replaced (all four). That was an expensive repair for something that came prematurely. I had premature brake wear on the...
What a piece of garbage! Last Toyota for me. So much wind noise i have to blast the radio just to hear the news.
I'l start by saying, I've had 7 Hondas previously to the 2010 Camry. Had issue with alignment from day one, took it to a large dealer in Omaha for warranty alignment, about 15K and 4 months after purchase. Told it was aligned and would be fine, at least it drove OK. 5K later, while rotating tires noticed heavy edge ware. Took it back and alignment was so far out, front toed in and back toed...