2005 Toyota Camry Repair and Maintenance
A guide to problems, costs, maintenance and repair for your 2005 Toyota Camry
Verified by mechanics, reported by drivers like you
Ask a mechanic in our community
Never overpay. Check prices with our estimator
2005 Toyota Camry ProblemsAutomatic Transmission May Not Shift Correctly at High Mileages
At higher mileages, (125,000-150,000) the automatic transmission may not shift correctly. This can be caused by the throttle position sensor being out of adjustment or a shift solenoid needing to be replaced. Typically the transmission does not need to be completely overhauled.
As the size of the Camry vehicle gets ever larger, there is a tendency to warp the front rotors. This will be felt as a shudder in the steering wheel when braking. The front rotors can be remachined, if there is sufficient material left, otherwise the front rotors will need to be replaced. It is recommended to use factory quality rotors because cheap quality rotors warp very easily and tend to squeak and squeal.
Cars equipped with an automatic transmission might experience a hesitation when accelerating. Revised software for the on board computer is available which may correct this problem. Software revisions are commonly most helpful on newer vehicles. once the mileage builds up a worn component could cause similar problems. Whenever major transmission work in performed, the transmission software should be updated as necessary.
2005 Toyota Camry QuestionsMy car has had a problem starting but it hit a bump and would not start ..it kicks when I turn the ignition but will not start (1 answer)
The starting problem which requires my keeping the key turned until the engine starts. It's been like this for over 6 weeks.
no movement stuck on full.
2005 Toyota Camry RecallsVarious Issues Due to Failed Crankshaft Pulley
The amount of adhesive applied between the inner and outer parts of the crankshaft pulley may be inadequate. If this is the case, the outer ring may become misaligned and/or not properly rotate with the inner ring, causing an abnormal noise and/or illumination of the Check Engine Light. In some cases, the power steering belt could come off resulting in a loss of power steering assist, increasing the risk of a crash. Dealers will inspect the crankshaft pulley and replace it if necessary.
These vehicle were sold without the required load carrying captivity modification label. Dealers will mail the corrected label to vehicle owners. Owners have the option of requesting that the dealer install the label. This recall is expected to begin on May 27, 2010.
Southeast Toyota is recalling 2005–2011 models for failing to comply with federal safety standards on tire selection and rims. Affected models were sold without the proper load-carrying capacity modification labels, which may cause the driver to overload the vehicle, increasing the chance of a crash. Dealers will mail the correct labels to the customer or install the label free of charge.