2007 Suzuki Forenza Repair and Maintenance

A guide to problems, costs, maintenance and repair for your 2007 Suzuki Forenza

2007 Suzuki Forenza Problems

Hard starting due to low fuel pressure

A hard starting condition may be due to low fuel pressure. Our technicians tell us the powertrain control module (PCM) should energize the fuel pump for 2 seconds when the ignition is turned on in order to properly pressurize the fuel system. Correcting this condition may require updating the PCM software.

Lack of Power Due to Failed Throttle Actuator

A lack of power may develop, accompanied by an illuminated Check Engine Light  with fault code P2106 stored in the powertrain control module (PCM). This fault can be caused by a throttle actuator which has only limited movement. The correction for this condition includes replacing the throttle actuator and updating the PCM software.

High and Low Beam Head Lamps May Stop Working

The head lights may stop working due to a failed connection at the multifunction head light switch. Our technicians tell us there is a harness connector repair kit available which should be installed in conjunction with dielectric grease to seal the connector. 2004-2006 models have been recalled for low beam and daytime running light malfunctions. For more information on this recall, please click here»

See More Problems (4)

2007 Suzuki Forenza Questions

i get my Suzuki engine fail. the motor can not start and make a noise, what can I do? (2 answers)

i get my Suzuki engine fail. the motor can not start and make a noise, what can I do?

Car crank but won't start change fuel pump change coil check fuses and no power to the fuel pum (1 answer)

I don't have any power in the fuel pump check relay and fuses and they are good

My forenza had a bad timing belt and cranks but no start. (1 answer)

I have changed the coil, plugs and wires and reset timing and replaced cam sensor as well since it failed ohm testing and still will not startup completely... I am weaiting on OBD2 scan tool to read into it more and reset pcm...any suggestions? Idler pulley had blown and both have been replaced w...

See More Questions (56)

2007 Suzuki Forenza Recalls

Headlight Switch And Module May Melt

The headlight switch and daytime running lamp module may overheat, melt and cause a risk of fire. Dealers will replace the signal switch, add a jumper relay kit and replace the daytime running lamp module free of charge to resolve the concern.

Front Seat Belt Buckle May Not Hold

The front seat belt may not latch correctly in the buckle. In rare cases, the locked seat belt may come loose unexpectedly, disengaging without pressing the release button. These malfunctions could cause the seat belt not to function as designed in the event of a crash, increasing the risk of injury. Dealers will replace the left and right front seat belt buckles to correct this concern. This recall is expected to begin on August 31, 2007. The Suzuki recall number is KY.

See More Recalls (2)

2007 Suzuki Forenza Reviews

I received a recall letter from Suzuki regarding the low/high beam headlamps and how this may cause overheating leading to a possible fire. Well after some research on the National Highway Traffic Safety Admin website Safecar.gov (NHTSA), I found there were over 197 complaints listed MOST to do with the Transmission/Gear Shift sensors. This car should be recalled on that alone!! I'm appalled...
I think they need to recall this car. Have had it in the shop since January. Full body throttle. Guess this is why they quit making them. Have had other problem also. air conditioner, oil plug, head lights.
My 2007 Suzuki Forenza sporadically has the check engine light coming on. Sometimes I am just sitting at a stop light waiting for the light to change and the engine light comes on. Other times, I have just slowly accellerated and the car jerks and the light comes on. Immediately goes into limp mode. I have had the car to 2 different repair shops who have replaced different senors, but the car c...

See More Reviews (5)