2000 Saturn LS Repair and Maintenance

A guide to problems, costs, maintenance and repair for your 2000 Saturn LS

No_car_image
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
Get a Repair Estimate For Your 2000 Saturn LS
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more

2000 Saturn LS Problems

Misfire due to failed ignition module or coil

    The ignition module or an ignition coil may fail causing an engine misfire and the check engine (SES) light to illuminate.

    Flush brake fluid every 60,000 miles

    Brake fluid can become dirty and may cause problems in the brake system; it should be flushed every 60,000 miles.

    Flush cooling system every 60,000 miles

    GM recommends replacing the engine coolant at 100,000 miles; however, our technicians tell us that the coolant may become contaminated and require a complete cooling system flush every 60,000 to 70,000 miles.

    See More Problems (5)

    2000 Saturn LS Questions

    Blinking check engine light (1 answer)

    checked the codes and none showed up but the light still blinks maybe a short some where bc sometimes it blinks and then stays on or off. 137k on the miles just bought not really sure whats going on or if there is nothing to worry about

    vehicle only starts when cool. could it be the ignition? (1 answer)

    why the vehicle wont start unless the engine is cool (1 answer)

    just purchased it 2 days ago. they replaced modular and reprogramed it. Runs for awhile, then wont start unless the engine is cooled down. Could it be the ignition?

    See More Questions (27)

    2000 Saturn LS Recalls

    Recall 05V245000
    ON CERTAIN SEDANS AND WAGONS, THE PLASTIC HOUSING IN THE REAR TAIL LAMP ASSEMBLY CAN BECOME DISTORTED IF THE BRAKE LAMPS REMAIN ON FOR AN EXTENDED TIME.
    Recall 03V231000
    ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH 2.2L L4 (L61) ENGINES, A FAILURE OF THE IGNITION CONTROL MODULE MAY CAUSE DETERIORATION IN IDLE QUALITY, REDUCTION IN OVERALL ENGINE POWER, AND THE VEHICLE MAY BE HARD TO START. CONTINUED OPERATION OF THE VEHICLE AFTER SUCH AN IGNITION MODULE FAILURE W...
    GM Recalls Multiple 2000-2001 Vehicles Due to Possible Seat Belt Failure

    The seat belt buckles may not have been properly heat-treated during the manufacturing process. This may cause the buckles not to function correctly during a collision, which may cause injury. Dealers will replace the seat belt buckles.

    See More Recalls (6)