2009 Saturn Aura Repair and Maintenance
A guide to problems, costs, maintenance and repair for your 2009 Saturn Aura
Verified by mechanics, reported by drivers like you
Ask a mechanic in our community
Never overpay. Check prices with our estimator
2009 Saturn Aura ProblemsTransmission Fault and/or Check Engine Light With Code P0716, P0776, P0717, P0777, P2714, P2715, and/or P02723
Vehicles with a 6speed automatic transmission may develop one or more of the following faults related to a broken 35R clutch wave plate inside the transmission: Illumination of the Check Engine Light with code P0716, P0776, P0717, P0777, P2714, P2715, and/or P02723, loss of reverse gear, slipping or harsh 3rd or 5th gear shift. Removal and dis-assembly of the transmission will be required to replace the broken 35R wave plate. It is also extremely important that all debris from the failed part be cleaned from the transmission while it is disassembled in order to try and prevent future problems.
A Loose or worn gas cap may cause Check Engine Light to illuminate.
Vehicles with certain V6 engines may illuminate the Check Engine Light one or more of the following codes: P0011, P0014, P0021, P0024, P0341, P0346, P0336, or P0391. Our technicians tell us that some vehicles may require a powertrain control module (PCM) software update to correct this issue. Other vehicles may have excess camshaft end play on one or both cylinder heads which will need to be corrected using special procedures outlined by GM.
2009 Saturn Aura QuestionsNone of the warning sounds are working in my car (2 answers)
For example, door open, key in ignition, seatbelt not on, etc. Could this be a fuse or is it a speaker out?
It mainly does it from a stop.
When tested, the fuel pressure was only at 30lbs so I purchased a Fuel Pump assuming that had to be the issue. The car will start but then die right away and that will continue until the battery runs down.
I was told to remove the rear seat and there I would find the access hatch to R&R the...
2009 Saturn Aura RecallsVarious Electrical Concerns
Increased resistance in an electrical connection at the body control module (BCM) may result in voltage fluctuations in the brake pedal sensor circuit. These fluctuations can cause concerns with various systems that monitor the position of the brake pedal, any of which would increase the risk of a crash. Dealers will attach the wiring harness to the BCM with a spacer, apply dielectric lubricant to both the BCM and harness connector and the BAS and harness connector, and will reprogram the brake pedal sensor to correct these concerns.
The vehicles being recalled are equipped with an electric power steering (EPS) assist system. The EPS can fail unexpectedly while driving. If this were to occur, steering ability would be maintained but much greater effort would be necessary to steer the vehicle, especially at slow speeds. One of four remedies will be applied depending on the model and year. Parts are not yet available so expect a second notification when they are.
On vehicles equipped with a 4-speed automatic transmission, the tabs on the transmission shift cable end may fracture and separate. If this were to occur, the shift lever and the actual position of the transmission gear may not match. The driver would be able to move the shifter to "Park" and remove the ignition key, but the transmission gear may not be in "Park." The vehicle may not be able to be restarted and the vehicle could roll away after the driver has exited the vehicle, resulting in a possible crash without prior warning. Dealers will install a retainer over the cable end or replace the shift cable as necessary. The General Motors recall number 12106.