2007 Saturn Aura Repair and Maintenance
A guide to problems, costs, maintenance and repair for your 2007 Saturn Aura
Verified by mechanics, reported by drivers like you
Ask a mechanic in our community
Never overpay. Check prices with our estimator
2007 Saturn Aura ProblemsTransmission Fault and/or Check Engine Light With Code P0716, P0776, P0717, P0777, P2714, P2715, and/or P02723
Vehicles with a 6speed automatic transmission may develop one or more of the following faults related to a broken 35R clutch wave plate inside the transmission: Illumination of the Check Engine Light with code P0716, P0776, P0717, P0777, P2714, P2715, and/or P02723, loss of reverse gear, slipping or harsh 3rd or 5th gear shift. Removal and dis-assembly of the transmission will be required to replace the broken 35R wave plate. It is also extremely important that all debris from the failed part be cleaned from the transmission while it is disassembled in order to try and prevent future problems.
A Loose or worn gas cap may cause Check Engine Light to illuminate.
Vehicles with certain V6 engines may illuminate the Check Engine Light one or more of the following codes: P0011, P0014, P0021, P0024, P0341, P0346, P0336, or P0391. Our technicians tell us that some vehicles may require a powertrain control module (PCM) software update to correct this issue. Other vehicles may have excess camshaft end play on one or both cylinder heads which will need to be corrected using special procedures outlined by GM.
2007 Saturn Aura QuestionsTraction Control light came on and engine losing power message came on and also engine light was on. All went out and car drove fine. What could be the problem (1 answer)
Also a couple of weeks ago, there was no antifreeze in the overflow. Dial is almost at the overheat no not overheating
warming up the car for approx. 10 to 15 minutes prior to driving. Blows cool air. Does not blow warm air until after approx. 5 minutes of driving. Blows cool air when idling.
2007 Saturn Aura RecallsVarious Electrical Concerns
Increased resistance in an electrical connection at the body control module (BCM) may result in voltage fluctuations in the brake pedal sensor circuit. These fluctuations can cause concerns with various systems that monitor the position of the brake pedal, any of which would increase the risk of a crash. Dealers will attach the wiring harness to the BCM with a spacer, apply dielectric lubricant to both the BCM and harness connector and the BAS and harness connector, and will reprogram the brake pedal sensor to correct these concerns.
The shift cable may fracture, which can mislead the driver into thinking the transmission is in a certain gear, while actually being in another. This can cause a safety issue, as when "Park" is selected, the vehicle may not be securely in "Park". Dealers will replace the shift cable assembly and mounting bracket free of charge to resolve the concern.
On vehicles equipped with a 4-speed automatic transmission, the tabs on the transmission shift cable end may fracture and separate. If this were to occur, the shift lever and the actual position of the transmission gear may not match. The driver would be able to move the shifter to "Park" and remove the ignition key, but the transmission gear may not be in "Park." The vehicle may not be able to be restarted and the vehicle could roll away after the driver has exited the vehicle, resulting in a possible crash without prior warning. Dealers will install a retainer over the cable end or replace the shift cable as necessary. The General Motors recall number 12106.