» » » 1994

Resources for the Repair and Maintenance of your 1994 Plymouth Grand Voyager

1994 Plymouth Grand Voyager

Image for car images Plymouth 1991 1995 Plymouth Grand Voyager size thumb

1994 Plymouth Grand Voyager Problems

Miscellaneous -- Verified

A problem with the sliding door track and door stops can allow the door to slide out of the track and fall off the vehicle. This is more common when doors are opened fast and allowed to hit the stops with a lot of force.

Miscellaneous -- Verified

The rear lift gate support (prop) attaching bolts may break, causing the lift gate to fall unexpectedly. Thorough inspection of the bolts is required; if the support washers are loose, the supports need to be replaced.

Miscellaneous -- Verified

Sometimes the vent windows' latch can pop open; if it will not stay closed or rattles, the latch assembly should be replaced.

Miscellaneous -- Verified

Hood misalignment, cowl cover misalignment, wiper module drain tube(s), and/or the lower plenum drain hose may cause the HVAC housing to leak water onto the passenger side floor. Diagnoses will be required to confirm the location of a water leak in the front passenger area.

Electrical & Lights -- Verified

An improperly-seated connection on the starter (coming from the battery) may cause the engine not to crank. Plastic must be ground off the cable terminal so it can sit flat and flush.

1994 Plymouth Grand Voyager Recalls (Recent)

Body, Interior & Misc., August 2, 1999

Summary: VEHICLE DESCRIPTION: MINI VANS. THE WIRING THAT INITIATES THE DRIVER AND/OR PASSENGER AIR BAG COULD ELECTRICALLY SHORT CIRCUIT TO GROUND. A SHORT CIRCUIT TO GROUND THAT EXISTS IMMEDIATELY AFTER TURNING THE IGNITION KEY TO THE "ON" OR "START" POSITION CAN CAUSE THE AIR BAG(S) TO INADVERTENTLY DEPLOY.

Learn more »

Body, Interior & Misc., September 29, 1995

Summary: VEHICLE DESCRIPTION: LIGHT DUTY PASSENGER MINIVANS WITHOUT REMOTE RELEASE. THIS IS NOT A SAFETY RECALL. THERE HAS BEEN NO DETERMINATION THAT A SAFETY DEFECT EXISTS WITH THE MINIVAN LATCHES. CHRYSLER IS CONDUCTING A SERVICE CAMPAIGN TO REPLACE THE LIFTGATE LATCH ASSEMBLY OF THE AFFECTED MINIVANS. IN A COLLISION, THE REAR LIFTGATE LATCH ASSEMBLY COULD OPEN.

Learn more »

Body, Interior & Misc., December 22, 1995

Summary: VEHICLE DESCRIPTION: LIGHT DUTY PASSENGER MINIVANS WITH REMOTE RELEASE. THIS IS NOT A SAFETY RECALL. THERE HAS BEEN NO DETERMINATION THAT A SAFETY DEFECT EXISTS WITH THE MINIVAN LATCHES. CHRYSLER IS CONDUCTING A SERVICE CAMPAIGN TO REPLACE THE LIFTGATE LATCH ASSEMBLY OF THE AFFECTED MINIVANS. IN A COLLISION, THE REAR LIFTGATE LATCH ASSEMBLY COULD OPEN.

Learn more »

Body, Interior & Misc., August 30, 1999

Summary: VEHICLE DESCRIPTION: MINI VANS. THE BOLTS USED TO ATTACH THE STRUT TO THE BODY AND THE REAR LIFTGATE CAN ACCUMULATE FATIGUE DAMAGE IF THREE FACTORS COMBINE. IF THE BOLT IS LOOSE, THE GAS STRUT IS OVER-PRESSURIZED, AND THE FREQUENCY OF OPENING AND CLOSING CYCLES IS HIGHER THAN FOR THE AVERAGE CUSTOMER, THE BOLT CAN FAIL.

Learn more »

Suspension & Steering, November 6, 2000

Summary: VEHICLE DESCRIPTION: MINI VANS EQUIPPED WITH 2-SPOKE LUXURY WHEELS MANUFACTURED JULY 1992 THROUGH JUNE 1993; OR EQUIPPED WITH 4-SPOKE SPORT WHEELS MANUFACTURED FROM JULY 1992 THROUGH SEPTEMBER 1993. THE STEERING WHEEL ARMATURE STAMPING CAN CRACK AND SEPARATE FROM THE CENTER HUB ATTACHMENT TO THE STEERING COLUMN.

Learn more »

1994 Plymouth Grand Voyager Questions and Answers

thechris, 1994 Plymouth Grand Voyager, 3.3L V6, Welch, MN

How do I reattach the center guide on the track for the sliding door? What would be the problem if I'm driving the vehicle and i can't accelerate (trany slipping)? It seems to work after ...

vandriver888, 1994 Plymouth Grand Voyager, 3.3L V6, Camarillo, CA

I have two serious oil leaks in this car. One of them involves a bolt we snapped off putting the oil pan back up. The other though and more serious one is the oil accumulating from the valve cover....

dog1960, 1994 Plymouth Grand Voyager, 3.3L V6, Bradford, RI

What is the easiest way to remove the rear wiper arm, its not nutted down, only press fit with a kocking clip.

larry007, 1994 Plymouth Grand Voyager, 3.3L V6, Tucson, AZ

Upon Replacing The rod bearing i snapped one of the bolt threads.Are these threads machine pressed or can i replace the bolt threads by taking the piston and connecting rod out and how would i go a...

I_need_help, 1994 Plymouth Grand Voyager, 3.3L V6, Huntsville, AL

what would cause the oil filter to blow off?it's happened several times now.theres an area on the filter that becomes unsealed and has irregular shape.

Write a Review About Your Car

1994 Plymouth Grand Voyager Reviews

The rear wiper kept blowing a fuse. I took the rear wiper motor apart, found nothing wrong. I then took the gear box apart. To do this I had to grind off the rivets to get the gear box apart. I found it was sticking for lack of grease. Repacked the gear box, drilled holes where the rivets were and put screws in. The rear wiper now works, and does not keep blowing the fuse.

Inherited this van from a family member. It was already on its third transmission when I got it, and now the transmission is not doing well. Engine is fine if not very durable. Seems to be a bad combination.

Recent Repair Estimates