Front brake rotors can wear causing a pulsation felt in the brake pedal. Our technicians tell us this condition is best corrected by replacement of the front rotors and brake pads.
Resources for the Repair and Maintenance of your 1991 Oldsmobile Silhouette
1991 Oldsmobile Silhouette
1991 Oldsmobile Silhouette Problems
The front struts may show signs of wear, or be excessively bouncy ride at freeway speeds. This may begin to occur at around 75,000 miles.
The high pressure power steering hose will commonly leak fluid and should be replaced if this is the case.
Brake fluid can become dirty and may cause problems in the brake system; it should be flushed every 60,000 miles.
The rubber section of an automatic transmission cooler line may develop a fluid leak . In some cases the leaking section of hose can be replaced. In others, the complete cooler line must be replaced to correct this concern.
1991 Oldsmobile Silhouette Recalls (Recent)
Summary: THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH THE SAFETY ACT. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. VEHICLE DESCRIPTION: MINIVANS EQUIPPED WITH FRONT BUCKET SEATS. THE FRONT SEAT RECLINER MECHANISM LOWER BOLTS CAN LOOSEN. A LOOSE BOLT COULD FATIGUE AND BREAK, RESULTING IN THE SEAT BACK FALLING REARWARD.Learn more »
Summary: VEHICLE DESCRIPTION: PASSENGER VEHICLES AND MINI VANS ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE FOLLOWING STATES: CONNECTICUT, ILLINOIS, INDIANA, MAINE, MASSACHUSETTS, MICHIGAN, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT AND WISCONSIN. THE REAR CRADLE BOLTS PULL THROUGH THE RETAINERS DUE TO CORROSION OF THE RETAINER. IF BOTH BOLTS PULL THROUGH, THE REAR CRADLE WOULD NOT LONGER BE SUPPORTED AT THESE MOUNTING LOCATIONS AND THE STEERING INTERMEDIATE SHAFT CAN SEPARATE FROM THE STEERING GEAR.Learn more »
1991 Oldsmobile Silhouette Questions and Answers
Where is the Fuel Filter Located on this Vehicle for Replacement and is it Difficult to Replace this Part?
we replaced the bearings in the steering wheel but its still a little wobbly.what else could be wrong, and how do i fix it
it was running fine till one i was putting gas in it and it wont crank.now when i turn the key over i can hear the blinkers ,
not getting fuel