2011 Nissan Altima Repair and Maintenance
A guide to problems, costs, maintenance and repair for your 2011 Nissan Altima
- Nissian Crankshaft and Camshaft Sensor Recall
- Check Engine Light Due to Failure of Catalytic Converter Closest to Cylinder Head
- Low Pressure AC Hose May Leak at Crimped Connection
- Rattle/CEL Due to Cracked Welds on Catalytic Converter Heat Shield
- Sunroof drain leak caused by pinched drain line at firewall
- Cost of Front brakes. Replace with OEM parts or ceramic. replace roters?
- Why does car whistles when driving?
- Sometimes my car jerks while I'm driving and it's anoyon
- I had an oil change then the transmission started to show I'm going 60 mph at 20
- What causes the loose fuel cap light to come on when the gas cap is tight
2011 Nissan Altima Problems
The engine may stall at times due to a failed crankshaft position sensor and/or camshaft position sensor, These sensors can fail intermittently as they warm with the engine. Sensors on certain models have been recalled by Nissan and will be replaced as necessary. Please visit our recall section for this model to see if your vehicle is covered by this recall.
The catalytic converter closest to the cylinder head can fail causing illumination of the Check Engine Light. Prompt repair of this problem is recommended because the catalyst material can be sucked into the engine and cause internal damage.
The AC system may blow warm air due to refrigerant loss caused by a leaking low pressure AC hose. These hoses commonly develop a leak at the hose crimp connection.
2011 Nissan Altima Questions
Car whistles while driving
Not all the time it happens service engine soon light came on still on happen two weeks ago car was jerks t h en it stopoed
2011 Nissan Altima Recalls
The bolt securing the transverse suspension link my not have been tightened correctly during vehicle assembly. A rattle or vibration may be noted if the bolt were to loosen. If it were to come out completely, the driver may experience difficulty controlling the direction of the vehicle, which could result in a crash. Dealers will replace the transverse link bolts and nuts and tighten them to the proper torque specification. This recall is expected to begin on August 1, 2011.