2007 Nissan Altima Repair and Maintenance
A guide to problems, costs, maintenance and repair for your 2007 Nissan Altima
Verified by mechanics, reported by drivers like you
Ask a mechanic in our community
Never overpay. Check prices with our estimator
2007 Nissan Altima ProblemsNissan Crankshaft and Camshaft Sensor Recall
The engine may stall at times due to a failed crankshaft position sensor and/or camshaft position sensor, These sensors can fail intermittently as they warm with the engine. Sensors on certain models have been recalled by Nissan and will be replaced as necessary. Please visit our recall section for this model to see if your vehicle is covered by this recall.
Crankshaft and camshaft position sensors can leak oil into the connector causing Check Engine Light illumination. The engine may also stall as a result. Leaking sensors should be replaced. Certain 2002 models were recalled for a separate camshaft and crankshaft sensor issue. For more information on the recall please click here»
Nissan issued a recall on the fuel pump for premature failure. There was an owner notification program and labels were placed on the fuel pump access panel and next to the AC charge label in the engine compartment.
2007 Nissan Altima Questionswhy isn't the outside temp displaying? (1 answer)
Outside temp reads icy------ but it is 95 degrees out
Advance said it is either the coolant is low or the thermostat is about to go. The car has not been running hot or shaking or anything. Does anyone know what it could be? They did not give me a code though
2007 Nissan Altima RecallsPassenger Air Bag May Not Deploy
This recall affects certain vehicles equipped Occupant Classification System (OCS) control units manufactured by Continental Automotive Systems. A varistor in the OCS control unit may have been manufactured out of specification. Under certain conditions, this could interupt the signal between the OCS and the air bag control unit (ACU), causing the passenger air bag to be suppressed in an accident. If the air bag does not deploy when needed in a crash, the risk of injury is increased. Dealers will test the signal between the OCS and ACU with a special tool to verify proper function. The seat cushion containing the OCS hardware will be replaced as necessary. The recall began November 4, 2008.
Nissan is recalling 2007-2008 Altimas because vehicles that have had the body control module (BCM) replaced during service at a dealership might have experienced inadvertent deactivation of the tire pressure monitoring system (TPMS) due to a software issue. If the TPMS is turned off, it would not alert the driver to a decrease in tire pressure, which could result in a crash. Dealers will check the TPMS function and reactivate it if necessary.
Nissan is recalling 2007 Altima models because if a sufficiently hot object enters the air filter housing through the engine fresh air intake system and contacts the engine air filter, the flammability characteristics of the air filter material are such that the filter may ignite, which may cause a fire. Dealers will replace the air filter with a new one that has improved anti-flammability material characteristics.