1994 Nissan Altima Repair and Maintenance
A guide to problems, costs, maintenance and repair for your 1994 Nissan Altima
Verified by mechanics, reported by drivers like you
Ask a mechanic in our community
Never overpay. Check prices with our estimator
1994 Nissan Altima ProblemsEngine Turns Over But Doesn't Start
Failure of the ignition power transistor can cause a "crank-no start" condition.
The engine may stall at times due to a failed crankshaft position sensor and/or camshaft position sensor, These sensors can fail intermittently as they warm with the engine. Sensors on certain models have been recalled by Nissan and will be replaced as necessary. Please visit our recall section for this model to see if your vehicle is covered by this recall.
1994 Nissan Altima Questions1994 Nissan altima 5spd won't start!!!!! New battery (1 answer)
My husband and I just bought this car and ever since getting it home we have had nothing but trouble with starting it. We replaced the battery, but when we put the key in the ignition and attempt to start it nothing except the lights come one and the heater starts blowing but it won't turn ov...
I had to keep charging my battery due to a bad alternator. One day it just quit running in the middle.of.the road,usually I would just charge the battery and it would start again but not this time. Battery is fully charged and it goes to start then.just doesn't please help!!
When I try to start the engine, I hear some gear slipping noise around the starter and will not start sometimes. If I give ten minutes or more it starts. Especially in the high temperature after driving it for a while, I need to give it some time to cool off. I've taken it to two garage and o...
1994 Nissan Altima RecallsNissan Recalls Passenger Air Bags on 1994-1995 Altimas
Nissan is recalling 1994-1995 Altimas following reports that passenger air bag deployments caused moderate-to-severe eye injuries. Nissan will replace the passenger air bag with a new, less powerful, air bag.
Nissan is recalling 1993-1994 Altimas because engine movement can be transmitted to the airflow meter/filter housing and support bracket, which can cause the throttle cable housing to pull out of the cable guide. This may prevent the throttle from returning to the idle position when the gas pedal is released, resulting in loss of throttle control that can cause an accident. Nissan will examine and repair/replace the throttle cable housing, insert a rubber stopper to maintain position for the cable, and replace the throttle assembly, if necessary.