On the 3.7L V6 and 4.7L V8 the Camshaft position sensor failure can cause the engine to crank but not start or it can cause intermittent stalling. A new camshaft position sensor will be needed.
Resources for the Repair and Maintenance of your 2007 Mitsubishi Raider
2007 Mitsubishi Raider
2007 Mitsubishi Raider Problems
A clunk or popping sound while turning is commonly caused by the intermediate steering shaft. Our technicians tell us that if this is the case, replacement of the upper intermediate shaft will be necessary.
Exhaust manifold bolts commonly break. If this occurs any broken bolts should be replaced as necessary, the exhaust manifold gaskets should also be replaced at this time.
If the automatic transmission intermittently stays in second gear (will not shift into a higher gear), restarting the engine may fix the condition temporarily. Updated software for the Powertrain Control Module (PCM) can solve this concern.
Under certain conditions, some models may shift into neutral even though reverse is selected with the gear selector. A software update to the Powertrain Control Module (PCM) will allow reverse engagement as long as the transmission has sufficient hydraulic pressure.
2007 Mitsubishi Raider Questions and Answers
I cant find a dipstick or anything to check the transmission fluid.
ac air wont blow out of vents it only comes out underneath the dash..
we found the problem initially at the haeness that runs by the a/c drier where the bracket holds in place just as it runs upwards to the ECM on the right fender. a few days later the vehicle start...