2008 Mitsubishi Outlander Repair and Maintenance
A guide to problems, costs, maintenance and repair for your 2008 Mitsubishi Outlander
- Temp gauge read high when first turned car on. What could be causing this?
- If the windshield wipers quit working would the whole computer need replaced?
- Why is blower making noise only after making hard right turn?
- The car vibrates when accelerating from 30-45 mph from under the engine..
- Where is motor on fan for heat and air located on vehicle?
2008 Mitsubishi Outlander Problems
Erratic HVAC blower motor operation may be caused by a failed blower motor and/or blower motor resistor. Our technicians tell us that if the blower motor resistor fails the blower motor should be checked. If the blower motor fails its functional test in should be replaced along with the failed blower motor resistor.
The automatic transmission may fail prematurely. Transmission overhaul or replacement may be necessary to correct this concern.
2008 Mitsubishi Outlander Questions
The car ran good yesterday but went to start it this morning and the temp was high. The fan came on , the belts looked good and coolant level was good. I was thinking it could be the thermostat.
I was told the computer in my outlander needed replaced because the wipers and the cigarette lighter both quit working.
Whenever the heater is on and I make a hard right turn, the blower starts making a LOT of noise. I have to turn it off and usually leave it off for a bit and or make a hard left to get it to stop making the noise.
2008 Mitsubishi Outlander Recalls
The pulleys that the drive the alternator, cooling fan and power steering pump mounted on the engine may experience unusual wear, resulting in the drive belt coming off. Dealers will replace the belt and any worn pulleys free of charge to resolve the concern.
The brake light switch can fail, preventing the brake lights from functioning when activated. Dealers will replace the brake lights switch free of charge to resolve the problem.
A check valve in the power brake booster may stick and cause the brake pedal to be harder than usual, usually after the vehicle has been shut off and then restarted. This may lead to longer stopping distances, which may create a safety hazard. Dealers will replace the brake booster check valve. The Mitsubishi recall number is SR-09-002. This recall began in April, 2009.