» » » 2009

Resources for the Repair and Maintenance of your 2009 Mitsubishi Lancer

2009 Mitsubishi Lancer

Image for car images Mitsubishi 2009 2011 Mitsubishi Lancer size thumb

2009 Mitsubishi Lancer Problems

Heating & Air Conditioning -- Verified

Erratic HVAC blower motor operation may be caused by a failed blower motor and/or blower motor resistor. Our technicians tell us that if the blower motor resistor fails the blower motor should be checked. If the blower motor fails its functional test in should be replaced along with the failed blower motor resistor.

Engine -- Verified

An engine overheating condition may develop due to a failed radiator cooling fan controller. The failed controller should be replaced to correct this issue.

Miscellaneous -- Verified

It is not uncommon for the clear coat paint to develop white spots and begin peeling. In most cases Mitsubishi will not cover out of warranty repairs for this condition.

2009 Mitsubishi Lancer Recalls (Recent)

Body, Interior & Misc., November 27, 2009

RepairPal Expert Overview:

Where heavy salt is used on the roads, the mixture of melted snow and salt may stick to the front impact sensors. Over time, this causes corrosion of the sensor, and could cause a possible delay in the deployment of the air bags in the event of a collision. The delay in deployment could cause an injury. Dealers will install new front air bag sensors with improved corrosion resistance. The recall began on November 27, 2009.

Learn more »

Brakes, May 4, 2009

RepairPal Expert Overview:

A check valve in the power brake booster may stick and cause the brake pedal to be harder than usual, usually after the vehicle has been shut off and then restarted. This may lead to longer stopping distances, which may create a safety hazard. Dealers will replace the brake booster check valve. The Mitsubishi recall number is SR-09-002. This recall began in April, 2009.

Learn more »

2009 Mitsubishi Lancer Questions and Answers

Visitor, 2009 Mitsubishi Lancer, Toms River, NJ

when should timing belt be changed and is it necessary ?

philipmitlan, 2009 Mitsubishi Lancer, Tacoma, WA

P2453 comes on after a long run on Motorways.
On clearing code it will come on again within 10 miles.
I've used particulate filter cleaner and high rev runs and does clear the problem, but i...

sgjmark, 2009 Mitsubishi Lancer, Presidio, TX

But then it worked a several days and then something made it go out again. I cannot figure out what is wrong with it.

zachs lancer, 2009 Mitsubishi Lancer, Wake Island, HI

replaced resistor and blower motor still nothing

Nunu27, 2009 Mitsubishi Lancer, Needles, CA

My coolant is low my car is not an evo

Recent Repair Estimates