2006 Mitsubishi Galant Repair and Maintenance

A guide to problems, costs, maintenance and repair for your 2006 Mitsubishi Galant

A rattle type noise may develop from one of the exhaust heat shields. Replacement of the affected heat shield may be required to correct this issue.

The crankshaft position sensor may fail causing a no start and/or stalling condition. Replacement of the failed sensor will generally corrects this concern.

The power windows may fail, often related to moisture inside the door. Affected components will need to be replaced. If possible some type of moisture protection could be added to try and prevent repeat failures.

See More Problems 12

Checked and replaced timming belt, there was no problem with the old belt. all the timming marks were aligned right. Still have low compression 90# to 50# Motor ran perfectly smooth when i last turned it off. still turns over but wont start. Plug look fine all rockers go up and down. Never overhe...

Have an obdII diagnostic tool and it says that all four of my o2 sensors have failed. Service engine light is on. Is there a central point where there may be a bad connection?

See More Questions 22

The attachment for the left fuel tank mounting strap may have been improperly formed, causing the metal to split. In the event the fuel tank is full and the vehicle is involved in a severe collision, the attachment bracket may break, allowing the fuel tank to drop down and possibly causing a fuel leak. Any fuel leak always increases the risk of a fire. Dealers will inspect the mounting bracket and perform repairs as necessary. This recall is scheduled to begin on September 20, 2008. The Mitsubishi recall number is SR-08-005.

See More Recalls 1