2005 Mercedes-Benz E55 AMG Repair and Maintenance
A guide to problems, costs, maintenance and repair for your 2005 Mercedes-Benz E55 AMG
Verified by mechanics, reported by drivers like you
Never overpay. Check prices with our estimator
2005 Mercedes-Benz E55 AMG Problems"Crank no Start" Due to Failed Crankshaft Position Sensor
The crankshaft position sensor may fail. Symptoms of this are: The engine will crank—but not start—especially when the engine is warm. The car may start again if it is left to cool off, but it may run roughly or have poor performance.
The ESP and BAS warning lights may illuminate due to a failed brake light switch. Replacement of the failed switch should correct this concern.
Water can damage the weight sensor in the front, passenger seat, causing the SRS (airbag) light to illuminate. There is an electrical component in the seat cushion susceptible to fluid damage. Any spills should be dried up immediately in order to try and prevent damage to the sensor.
2005 Mercedes-Benz E55 AMG QuestionsBrake pads (1 answer)
I'm thinking ti install new brake pads to my car but i'm thinking to install EBC pads the yellow ones. Should I install them or just go with the original ones. Any advice or suggestions?
2005 Mercedes-Benz E55 AMG RecallsIncorrect Software Calibration May Cause Fuel Pump to Remain Powered in a Collision
There is a faulty software calibration that affects several areas including shutting off the fuel supply in a collision. This could cause a fire hazard during an accident. Dealers will reprogram this software. The Mercedes-Benz recall number is 2008 070001. This recall began during August, 2008.
Due to deterioration of the wiring harness connection or failure of the hydraulic pump, the sensotronic brake control (SBC) system may default to the hydraulic back-up mode. In the back-up mode, the driver has braking power sufficient to stop the vehicle, but greater brake pedal pressure is required and brake pedal travel will be noticeably longer. Dealers will install a bracket and replacement ground wire to the SBC pump unit on all affected vehicles. Additionally, dealers will inspect and replace the SSC pump unit in certain SL models. The Mercedes-Benz recall numbers are 2005070007 AND 2005110001.
High mileage combined with a high number of brake actuations, or a high brake actuation frequency, can cause the pump motor of the SBC to run out of permissible tolerances. As a result, excessively high pressure may build the high pressure line of the brake system. If this occurs, the system will switch into the hydraulic function mode as designed. Sensotronic brake control is disabled when the brake system is functioning in the hydraulic mode. Dealers will inspect the SBC hydraulic unit and replace it if necessary to correct this concern. The Mercedes-Benz recall number is 2004 050014.