» » » 2008

Resources for the Repair and Maintenance of your 2008 Mercedes-Benz CL600

2008 Mercedes-Benz CL600

Image for car images Mercedes Benz 2007 2009 Mercedes Benz CL600 size thumb

2008 Mercedes-Benz CL600 Problems

Suspension & Steering -- Verified

The active body control system can leak fluid from numerous areas, including the tandem pump, hydraulic lines, struts, and/or seals. If it is not repaired, the vehicle ride height could drop too low and cause damage to the undercarriage.

Engine -- Verified

Engine misfires (rough running) and lack of power are commonly caused by ignition coil pack or ignition module faults. Proper diagnoses should isolate the cause and prevent unnecessary replacement of good parts.

Heating & Air Conditioning -- Verified

<!DOCTYPE html PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN" "http://www.w3.org/TR/REC-html40/loose.dtd">
The evaporator temperature sensor can fail, causing the AC compressor not to cycle. If the AC compressor does not turn on, the AC system will not blow cold air. If the compressor is stuck on, the air will be very cold at first, before warming up.

Drive Train -- Verified

A vibration felt through the center floor of the vehicle can be caused by cracked and/or shredded driveshaft flex discs, resulting in excessive driveshaft movement. If not repaired, damage to the driveshaft center support bearing, transmission, or differential can occur.

Brakes -- Verified

The anti-lock brake system (ABS) modulator assembly may fail due to dirty brake fluid. Our technicians recommend a complete brake system flush every two years in order to help prevent this problem.

2008 Mercedes-Benz CL600 Recalls (Recent)

Body, Interior & Misc., November 19, 2007

RepairPal Expert Overview:

The rear outer seat belts may not latch correctly when used with certain child safety seats, increasing the risk of injury in the event of a crash. Dealers will replace the affected seat belts. This recall is expected to begin on November 19, 2007. The Mercedes-Benz recall number is 2007-100002.

Learn more »

Body, Interior & Misc., May 2, 2008

RepairPal Expert Overview:

Transistors used in the front signal acquisition and actuation module (SAM-F) may have been damaged during module assembly. As a result, the module could fail without warning, increasing the risk of a crash. Dealers will inspect and replace the affected modules as necessary. This recall is scheduled to begin on May 2, 2008. The Mercedes-Benz recall number is 2008 030005.

Learn more »
Recent Repair Estimates