2007 Mazda Mazda6 Repair and Maintenance
A guide to problems, costs, maintenance and repair for your 2007 Mazda Mazda6
- suspension ball joint creaking noise
- My 2007 Mazda6 S Sport VE, shakes and rumbles when idle. It's not the EGR gasket, EGR o-ring, Intake gasket, spark plugs, I replaced them all, don't know what the problem is, have you heard about this problem? Can you tell me the fix?
- My car has a new battery,how could that impact the alarm system?
- I replaced the battery in the car, it lights up but does not start
- right turn signal turns on 4 way hazard lights when used
2007 Mazda Mazda6 Problems
Some models may have a problem with stalling under light acceleration. Updated software for the powertrain control module (PCM) is available which may help with this concern.
I went in for an oil change today at the Mazda dealership and was told that I had a battery cable corrosion issue. My service rep told me the cable wires that attach to the battery are corroded and that I would need to replace them with a new wiring harness as soon as possible. Due to this problem, I also need a new battery. The estimated cost is $600. The service rep said at any time the cables could snap causing the car to completely sto...
Mazda issued an emissions recall due to a problem with the Swirl Shutter Valve; this would cause the Check Engine light to illuminate.
2007 Mazda Mazda6 Questions
what should I do in detail so I can know how to spend my money the right way I really need the best answer thank you
no check engine light on but the fluid is dirty
2007 Mazda Mazda6 Recalls
This limited regional recall is for vehicles currently registered or first sold in Florida, Puerto Rico, Hawaii and the U.S. Virgin Islands, and equipped with Takata-brand air bag inflators. Upon deployment the driver and/or passenger airbag inflator could rupture, increasing the risk of personal injury. Mazda dealers will replace the affected airbag inflator modules to correct this concern.
On vehicles equipped with California emission systems, the protective coating on the exterior of the fuel tank may have been damaged during vehicle assembly, reducing corrosion resistance. Rusting could lead to perforation of the fuel tank, resulting in a fuel leak. Fuel leakage always increases the risk of a fire. Dealers will inspect the fuel tank and repair the coating or replace the tank as necessary. This recall is scheduled to begin on August 28, 2008. The Mazda recall number is 5008H.
2007 Mazda Mazda6 Reviews
my car is having the same problem, no blinkers, key remote wont work, dome light does not work. the mazda dealer said it is the BMI part, cost about 600-700 Dollars to fix. the part has gone out because it got wet. well guess what I live in Washington State and it rains all the time here. Car had less than 60,000 miles when it started to go out.
Bought new 2007 - no issues - I have 123,000 miles on it. Replaced 4 tires, x 2, brakes front and rear x 1. Great car. Bought a second Mazda end of 09 - 2010 3.
I HAVE HAD A SUDDEN INCREASE IN MY HEAT GAGE ALTHOUGH THERE IS NO WATER DID A RADIATOR PRESSURE TEST SHOWS HEADGASKET BLOWN NO WATER THOUGH RADIATOR WATER REMAINS FULL COULD IT BE THE THERMOSTAT STUCK OR A BLOCKAGE IN THE WATER PUMP THEO CAPETOWN SOUTH AFRICA THEODRUMMER@TELKOMSA.NET