Close

1991 Mazda B2600 Repair and Maintenance Costs

A guide to repairs, service, and maintenance costs for your 1991 Mazda B2600

1991 Mazda B2600 Problems

Cranks But Won't Start Due to Internal Distributor Fault

If the engine cranks but won't start, the fault may be internal to the distributor. Diagnosis will show no spark and trouble codes for the crankshaft position sensor (CKP) or the camshaft position sensor (CMP). Our technicians recommend replacement of the complete distributor assembly if these conditions occur.

Transmission Shifts In and Out of Overdrive

If the automatic transmission shifts in and out of overdrive while cruising, it may be from a coolant thermostat that is stuck open. The engine must reach full operating temperature for the overdrive to engage properly. If possible, check to see the engine is running at full operating temperature while cruising.

ABS Light Flashing

If the Anti-lock Brake System (ABS) Light is flashing, the "Room" fuse may be missing or open (blown). Replace the fuse if needed and check the light again for flashing. If the fuse pops again, further diagnosis will be needed. If the light is not flashing, and on continuously, that means the system malfunction that needs ABS System diagnosis.

See More Problems (3)

1991 Mazda B2600 Questions

Ticking fuel injector or lifter plunger causing ticking (1 answer)

I recently acquired a mazda b2600i and I fixed a leaky valve cover on it. It ran get for about 2 months and then I noticed I needed to do an oil change bad, so the plunger may have been clogged during this period. I put 10w-40 synthetic in it, then about 2 weeks later it starts to tick from the a...

Which is the number one cylinder on a Mazda 91 B 2600 (1 answer)

How do you adjust the hydraulic lifters? (2 answers)

I have one ticking lifter.I removed the valve cover to take a looknd sure enough the exhaust valve on the #2 cyclinder is the problem looks like the plunger where you set the lash is stuck or clogged.Is there a way to remove it from the rocker without disassembeling the entire rocker arm?

See More Questions (17)

1991 Mazda B2600 Recalls

Recall 92V139000
THE STEEL SPOKED WHEEL ASSEMBLIES INSTALLED AS STANDARD EQUIPMENT OR OFFERED AS AN OPTION ON THESE VEHICLES WERE IMPROPERLY WELDED DURING ASSEMBLY OF THE WHEEL RIM TO DISK, WHICH CAN CAUSE CRACKS IN THE WHEEL.

See More Recalls (1)

1991 Mazda B2600 Reviews

Rated
based on 1 customer reviews
THIS TRUCK HAS BEEN A SERIOUS HEADACHE FROM DAY ONE

See More Reviews (1)