1994 Mazda 929 Repair and Maintenance

A guide to problems, costs, maintenance and repair for your 1994 Mazda 929

No_car_image
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
Get a Repair Estimate For Your 1994 Mazda 929
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more

1994 Mazda 929 Problems

Knocking from suspension on rough roads due to worn or loose sway bar links
A knocking sound heard from the front or rear suspension while driving over rough roads may be caused by the sway bar linkages. The linkages should be inspected for tightness and condition; there are redesigned linkages if replacement is necessary.
Rumbling Noise, Possible Loss of Power

If a rumbling noise is heard from the engine, along with a possible loss in power, it may be caused by a collapsed hydraulic timing belt tensioner creating excessive cam backlash. Our technicians recommend replacing the timing belt and water pump at the same time, if they have not been recently replaced.

ABS Light Illuminated Intermittently

If the ABS light is on intermittently, it may be due to a loose ABS ring on the rear axle. If a loose ABS ring is found during inspection, replacement of the ABS ring and affected drive axle may be necessary.

See More Problems (3)

1994 Mazda 929 Questions

car will not shift out of park into drive, when out in one gear (1 answer)

car will start and run but will not shift out of park to drive, push release on side of shifter stays in one gear.also gauges on dash will not register

What else can I check to see why my car want start? (2 answers)

I replaced the starter and battery. I put on new battery ends. The starter will engaged but want spin. I traced the ignition wire and checked it with a volt meter it read 12v when I turned the switch to actually crank the car. When I plug the ignition wire into the wire that runs to the starter t...

location of the fuel filter (1 answer)

where is the location of the fuel filter the owner manuel does not specify

See More Questions (5)

1994 Mazda 929 Recalls

Ignition Electrical Switch Overheats

The electrical portion of the ignition switch may lack proper grease at the contact points, leading to the points becoming conductive and overheating. Dealers will replace the ignition switch free of charge to resolve the concern.

See More Recalls (1)