1992 Mazda 929 Repair and Maintenance

A guide to problems, costs, maintenance and repair for your 1992 Mazda 929

1992 Mazda 929 Problems

Knocking from suspension on rough roads due to worn or loose sway bar links
A knocking sound heard from the front or rear suspension while driving over rough roads may be caused by the sway bar linkages. The linkages should be inspected for tightness and condition; there are redesigned linkages if replacement is necessary.
Runs Poorly After Replacing Distributor Cap and Rotor

Original Equipment or high quality aftermarket ignition parts are recommended on this model. A lower quality distributor cap and rotor may be problematic when installed.

Rumbling Noise, Possible Loss of Power

If a rumbling noise is heard from the engine, along with a possible loss in power, it may be caused by a collapsed hydraulic timing belt tensioner creating excessive cam backlash. Our technicians recommend replacing the timing belt and water pump at the same time, if they have not been recently replaced.

See More Problems (4)

1992 Mazda 929 Questions

why wont my car rev over 2000 rpm (1 answer)

when 1st start can rev freely until it comes back under 2000 then wont go above it, like its in limp mode.or starving for gas. have replaced plugs, distributer cap, throttle position sensor, water temp sensor.

changed battery turmal now the starter wont engade someone said it was my securt (2 answers)

what do i do to it

What would cause a loud squeal inside ac air compressor at start up? (2 answers)

Mechanic replaced belts with water pump. Sound comes from inside air compressor.

See More Questions (4)