A pulsation may be noted upon brake application. This condition is commonly caused by warped brake rotors. Our technicians recommend inspecting both front and rear brake rotors when this condition occurs. Brake pads should be replaced along with any warped rotors to correct this condition.
Resources for the Repair and Maintenance of your 2001 Land Rover Range Rover
2001 Land Rover Range Rover
2001 Land Rover Range Rover Problems
A chirping type noise may be noted from the engine area, mostly at idle. This type of noise is generally caused by a faulty drive belt idler pulley. Our technicians tell us a revised pulley is available to correct this concern. Chirping Type Noise From Engine at Idle
In severe wet conditions, water may enter the anti-lock brake system (ABS) modulator electrical connector resulting in corrosion and illumination of the ABS warning light. Our technicians tell us revised modulator ground leads are available to better seal the connector. If corrosion is found in the electrical connector the connector will need to be repaired as necessary and the new ground leads installed.
2001 Land Rover Range Rover Recalls (Recent)
Summary: VEHICLE DESCRIPTION: CERTAIN SPORT UTILITY VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 114, "THEFT PROTECTION." WATER CONTAMINATION OF THE AUTOMATIC TRANSMISSION OIL CAN LEAD TO VARIOUS FAILURE MODES OF THE TRANSMISSION. ONE OF THESE FAILURE MODELS RESULTS IN INCORRECT OPERATION OF THE PARK LOCK FUNCTION THAT COULD ALLOW A VEHICLE TO ROLL AWAY IF PARKED WITHOUT THE HANDBRAKE PROPERLY SET.Learn more »
2001 Land Rover Range Rover Questions and Answers
I will be converting my Range Rover from it's original air suspension to a more reliable and more cost efficient spring suspension and I would like to know what would be considered adequate la...
I purchased a fuel filter for this SUV, and I had two mechanics state they can't find a fuel filter to replace...so why would they look up the make, model, and sell a fuel filter if there isn&...
Mass Air Sensor cost including installation
just changed valve cover gaskets,throttle body gaskets[pre-heater] , new wires and plugs[gap .38].needs to be cranked twice now once before. idle at 650 rpm. before 750.